8 & 10MM GLOW PLUG HEATER ELEMENT
REMOVAL SET
MODEL NO:
VS315
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
8
DO NOT
use tools if damaged.
8
DO NOT
attempt to start engine or move vehicle whilst tools are fitted and work is in progress.
9
Maintain tools in good and clean condition for best and safest performance.
9
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey stockist.
9
Wear suitable clothing to avoid snagging.
DO NOT
wear jewellery and tie back long hair.
9
Ensure any disconnected fuel pipes are plugged to avoid spillage.
9
Account for all tools and parts being used,
DO NOT
leave them in or near the engine. Return all parts to the case and store this in a
safe, dry, childproof location.
IMPORTANT:
These instructions are provided as a guide only. Always refer to the vehicle manufacturer’s service instructions, or a
proprietary manual, to establish the current procedure and data.
WARNING!
The warnings referred to in this guide cannot cover all possible conditions and situations that may occur. It must be
understood that common sense and caution are factors which cannot be built into this product, but must be applied by the operator.
2. INTRODUCTION
For removing the heater element that can break off during glow plug removal. Saves time not having to remove the cylinder head. Works by
drilling/tapping a thread into the broken element so the supplied glow plug adaptors can be used to extract. Supplied with seven drilling/tapping
guides and five glow plug extraction adaptors with either a M8 or M10 thread.
3. CONTENTS
KEY:
1
. . . . . . .
Drilling Guides: M8 x 1, M10 x 1, M10 x 1.25mm
2
. . . . . . . . . . . . . .
Tapping Guides: M8 x 1, M10 x 1.25mm
3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Drills: Ø 2.5, 3.3mm
4 . . . . . . . . . . . . . . . . . . . . . . .
Taps: M3 x 0.5, M4 x 0.7mm
5
. . .
Extraction Adaptors: M8 x 1, M10 x 1, M10 x 1.25mm
6 . . . . . . . . . . . . . .
Threaded Rods: M3 x 0.5, M4 x 0.7mm
7
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Extractor Nuts
fig.1
V
S315 Issue 2 (4) 21/05/20
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
