1. INTRODuCTION
ratchet type axle stands, with cast iron support posts. Features angled teeth in posts, which prevent accidental release of the load, with the more
weight applied, the tighter the post is locked. Sold in pairs.
2. SPECIfICATION
Model no: ................................................................. VS2012
capacity (per stand): ........................... 12 tonnes (12,000 kg)
capacity (per pair): .............................. 24 tonnes (24,000kg)
minimum height: ......................................................... 450mm
maximum height: ........................................................ 710mm
3. ASSEMbLY
3.1.
Insert the centre column into the base frame and stand (fig.1).
3.2.
ensure the toothed side of column will engage with the locking lever mechanism (fig.2).
3.3.
Screw in the screw on the side to stop the centre column coming out.
3.4.
check the base frame and stand is in good condition and has not suffered damage during transit.
4. OPERATION
4.1.
refer to vehicle handbook for correct jacking procedure. check to ensure manufacturer’s recommended jacking points are in good
condition.
4.2.
Position the stands beneath the recommended jacking points.
4.3.
to adjust the stands: Hold the control lever up while lifting the centre column to required height. Push the control lever down to lock
the pawl into the central column teeth (fig.1 and fig.2).
WARNING! ENSuRE PAWL IS fuLLY ENGAGED WITH TEETH.
4.4.
carefully and slowly lower vehicle onto stands. ensure load bearing points sit in the centre of the saddles and that the stands are
stable. Also ensure that there are no objects or persons that could impede the safe lowering of the vehicle onto the stands.
▲
DANGER!
You must follow tHeSe instructions carefully and ensure you
DO NOT
load the stands off centre. Failure to adhere to
these warnings may cause damage, injury or loss of life!
5. MAINTENANCE
5.1.
Before each use, check that stands and stand welds are not cracked and that there are no missing or damaged parts.
5.2.
Any suspect axle stands must be removed from service immediately.
5.3.
due to the potential hazards associated with stands, do not misuse, or make any modification to, the stands or components.
5.4.
It is the responsibility of the owner to ensure that the operator has read these instructions together with the safety features on the
side of the stand and that the operator is aware of the stand’s uses and limitations.
fig.1
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
no liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole uK distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. edmunds, Suffolk.
IP32 7Ar
www.sealey.co.uk
01284 757500
01284 703534
Web
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, dispose of the product according to local
regulations.
VS2012.V2 | Issue 4 - 02/12/16
Original Language Version
© Jack Sealey Limited
