p
WARNING!
Pump must be used in accordance with Health & Safety, government, local authority, and water authority rules and regulations.
3
Familiarise yourself with application and limitations, as well as the potential hazards peculiar to the pump.
p
WARNING!
Disconnect the pump from the battery before changing accessories, servicing or performing any maintenance.
3
Maintain the pump in good condition. Keep the pump clean.
3
Replace or repair damaged parts (use an authorised service agent).
Use genuine parts only. Non authorised parts may be dangerous and will
invalidate the warranty.
3
If the bottom of the liquid container is covered with sludge, sand, gravel or mud etc, suspend the pump or place it on a raised base to
operate above the solid matter. Sand and such substances will reduce working life of pump, and invalidate your warranty.
3
In flood situations, user is responsible for ensuring that appropriate back up procedures, alarms etc are correctly installed in case of pump failure.
3
In swimming pool, fish ponds, etc, ensure location is clear of people and animals (including removal of fish from pond). Note: this pump is not
designed for continuous use in a fish pond or similar water feature or display.
8
DO NOT operate the pump if any parts are damaged or missing as this may cause failure and/or personal injury.
8
DO NOT use the pump for any purpose other than for which it is designed.
8
DO NOT use to pump septic tanks or settling pits.
8
DO NOT operate pump out of water. The pump pick up area must be completely submerged during operation.
8
DO NOT operate the pump during freezing temperatures. DO NOT leave the pump in water that may freeze.
8
DO NOT carry the pump by its electrical cable, or outlet pipe.
3
When not in use remove battery clips from terminals. Rinse pump, drain out any liquid and store in a frost free, safe location.
p
WARNING!
Whilst the pump may be used in dirty water, it is not to be used for such water containing large particles e.g. mud, weed etc.
p
WARNING!
DO NOT allow uncontrolled discharge of contaminated water/harmful chemicals thus polluting the environment.
INSTRUCTIONS FOR:
SUBMERSIBLE TRANSFER PUMP
Model:
TP94
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION & SPECIFICATIONS
Self priming portable pump for use with diesel, various chemicals, and fresh or dirty water. Suitable for re-fuelling/fluid transfer of plant, agricultural
and marine equipment on site. The pump is supplied with a 3mtr outlet hose and stainless steel nozzles, plus a 4mtr battery cable with clips.
Flow rate at hose end:
16.5 ltr/m
Voltage:
12V
Current:
4.5amp / DC
Pressure:
15psi / 1bar
Diameter:
53.5mm
Length:
145mm
Weight:
0.6kg
Duty Cycle:
15mins
3. CONTENTS
Unpack the product and check the contents.
Ensure that there is no damage. If any problem is noted,
contact your supplier immediately.
A .......... 3 metre outlet hose + stainless steel nozzle
B .......... Motor
C.......... Impeller guard
D.......... Filter
E .......... End cap
F .......... Battery clips
G.......... 4 metre battery cable
H.......... Seal cap
TP94 - 2 - 240703
