2. iNtrOductiON
e
lectric drum mounted pump designed for pumping diesel, kerosene, antifreeze, AdBlue®, detergents, water and light oils up to a viscosity of
100cst. Fitted with built-in fuse for protection, with a silenced motor keeping noise to a minimum. Telescopic suction tube features a stainless
steel filter at the base of the tube, preventing foreign matter from entering the motor. Pump housing features a convenient holder for storing
the dispensing nozzle. Includes 230V mains adaptor and 12V battery clips allowing user to operate unit with whichever supply is available.
Supplied with a 2”BSP adaptor, 2mtr hose and manual dispensing nozzle with spout.
3. SpEcificatiON
model no ....................................................................
TP6818
V
oltage ......................................................................
12/230V
current ......................................................................
0.4/0.6A
Power .............................................................................
23W
duty cycle ...............................................................
30min/hr.
flow rate .................................................................
19ltr/min
fuse ...................................................................................5A
4. OpEratiON
4.1.
Adjust the length of the suction pipe to fit the drum (fig.2).
4.2.
Insert the suction pipe into the drum (fig.3).
4.3.
Tighten the drum bung adapter (fig.4).
4.4.
select correct power supply cable and push into socket on
back of pump. Either connect to 12V battery supply using
clips or plug into 230V supply using three pin plug and
transformer lead.
4.5.
Pull out the nozzle from the nozzle holder (fig.5).
4.6.
Place the nozzle into the receiving container (fig.6).
4.7.
Switch on the pump by moving the switch up (fig.7).
4.8.
Pull the nozzle lever and start supplying the liquid (fig.8).
4.9.
Release the leaver when the liquid supply is complete (fig.9).
4.10.
s
witch off the pump by moving the switch down (fig.10).
4.11.
Lift the nozzle up and pull the lever (fig.11).
4.12.
d
rain the liquid in the hose back into the drum (fig.12).
4.13.
i
nsert nozzle into the nozzle holder for storage (fig.13).
5. maiNtENaNcE
5.1.
switch off and remove power supply before any maintenance.
5.2.
clean the pump and inspect all piping connections for leaks.
5.3.
clean the filter by removing end cap remove filter and clean.
5.4.
store in a dry, childproof location.
t
P6818 | Issue 1 02/11/16
Original Language Version
© Jack sealey limited
fig.1
fig.2
fig.3
fig.4
fig.5
fig.6
fig.7
fig.8
fig.9
fig.10
fig.11
fig.12
fig.13
