![background image](http://html.mh-extra.com/html/sealey/tc10a/tc10a_instructions_1227358001.webp)
instructions for
tyre changer - assist arm for tc10
model no:
tc10a
thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
crushing of
hands hazard
Wear eye
protection
Wear protective
gloves
Wear ear
protection
Wear safety
footwear
Wear protective
clothing
1. safety
Warning!
ensure that Health & safety, local Authority regulations and general workshop practice regulations are adhered to
when using tyre changer. read and fully understand instructions and safety labels attached to machine.
9
Wear appropriate Personal Protective equipment. A full range of Personal Protective equipment is available from your sealey stockist.
9
Wear suitable clothing to avoid snagging.
Do not
wear jewellery. tie back long hair.
9
maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.
8
Do not
use tyre changer assist arm if damaged.
9
this machine should only be operated by trained personnel.
9
This machine should only be used for the purpose for which it is intended and not modified in any way.
9
Warning!
the warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. the operator/
user must apply caution and common sense.
2. introDuction
t
he assist arm is a must have for mounting and dismounting low profile and run flat tyres and is for use in conjunction with Model No. TC10 Tyre
changer. operated by air supply from tyre changer. single air ram operates three separate arms with one control lever. see sealey website for
demonstration video.
3. specification
model no .....................................................................
TC10A
Height ......................................................................
1220mm
Height when mounted ..............................................
1550mm
operating pressure ...............................
8-10bar (115-145psi)
Weight ............................................................................
72kg
4. positioning anD assembly
4.1.
Remove packaging and check contents according to the accessory list and fig.1. Clean for assembly. The assembled appearance is
as shown in the fig.2.
fig.1
fig.2
t
C10A | Issue 1 06/02/18
Original Language Version
© Jack sealey limited
AccessorY list:-
1. Ø8PU hose
2. Ø8 Y-Tee
3. Plate
4. Cushion
5. Screw M10X130 (nut,flat washer) 4sets
6. Screw M10X25 (nut,flat washer) 2sets
7. Screw M10X20(flat washer) 2sets
8. fix plate
9. tool box.
f
ig.2 Key
1. Roller Arm - to push down on the top bead of the tyre. Used when removing
and fitting the tyre.
2. Disc Arm - to push up the bottom tyre bead. Used when removing the tyre.
3. Bead Holding Arm - to hold the top bead in position when fitting so tyre bead
does not slip off. Used when fitting the tyre.