5.3.5.
Tilt back the column and cut off the tie on the fixed shaft fig.7.1 and pull out the piston rod.
5.3.6.
Position the column as shown in fig.8. Remove the circlip from one end of the shaft fig.3.2 and pass the shaft through the 16mm hole,
vertical retaining bar fig.8.3, piston rod fig.8.4 and through the hole on the opposite side of the column. Attach circlip to shaft.
5.3.7.
To install the horizontal arm protective cover, remove the cap nut fig.10.1, the screw at the back end fig.10.2 and the screw fig10.3 at
the top end of the vertical cap fig.10.4. Remove cap fig.10.4.
Warning!
when detaching the vertical shaft cap , support the vertical shaft to prevent the vertical shaft from falling.
5.3.8.
Remove packaging from protective cover. Position as shown in fig.11.
5.3.9.
Twist on the cap nut fig.11.2 and screw fig.11.3. Install the vertical shaft spring fig11.4, cap fig.10.4 and screw fig.10.3.
5.3.10. Adjust the column positioning screws on the two sides of the column. release the nuts on the two sides and adjust the gap between
the head of the screw and the side of the column to 0.03mm fig.12. and then lock the nut.
5.3.11. c
onnect the air source, use the lock air valve push button to lock the horizontal arm fig.2.2. Operate the column tilt pedal fig.2.8 and the
column will tilt backwards by about 25° . the speed of the movement of the column has been set to be about 2 seconds per stroke. After
a time in operation, the speed may increase or decrease, you can use the speed adjusting valve to adjust the speed. to do this
loosen the nut and turn the screw, turn the screw clockwise to decrease and counter-clockwise to increase. After adjustment, tighten the
nut.
5.3.12. fix the side panel and tool box removed in step 4.2.2.
5.4.
compressed air installation
5.4.1.
the compressed air regulator assembly can be found in the accessory box.
5.4.2.
Use the screw provided to fix the assembly on the right hand side (viewed from the back) of the body fig.13.
fig.7
fig.9
fig.11
fig.8
fig.10
fig.12
tc10 | issue 1 02/02/18
Original Language Version
© Jack sealey limited
