6. TrouBLeShooTInG
Problem
Possible Cause
Solution
Fan does not turn when electricity is
connected
no electric power to heater
Check current at outlet. If voltage is correct,
inspect extension and power cords for cuts,
frays or breaks.
B
lades of fan in contact with heater housing C
heck housing for damage. Be sure there
are no dents in the housing obstructing the
fan.
Fan blades bent
Straighten all fan blades
Fan motor defective
Replace motor assembly
Heater will not ignite
no spark at ignition electrode
I
nspect electrode wire. Re-attach or
tighten if loose. Inspect ignition electrode
and replace if necessary. Inspect all other
electrical components.
Incorrect spark gap
Set ignition electrode gap to 4mm.
Corroded electrodes
Replace ignition electrode plug
Heater stops running by itself
Temperature inside heater is too high,
causing thermal switch to shut down
operation.
If the heater input or output is restricted,
the inside temperature can become too hot.
Keep the areas in front and behind clear of
obstructions.
dust or debris accumulated in heater.
Clean inside of heater
Sealey Group, Kempson way, Suffolk Business park, Bury St edmunds, Suffolk. Ip32 7ar
01284 757500
01284 703534
www.sealey.co.uk
note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: no Liability is accepted for incorrect use of this product.
warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
weee reGuLaTIonS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
envIronMenT proTecTIon
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
LP170 Issue: 3 (1) 02/07/18
Original Language Version
© Jack Sealey Limited
