6. MAINTENANCE
!
WARNING!
Disconnect the saw from the mains power before changing accessories, servicing or performing any maintenance.
6.1.
Regularly clean the saw to remove dirt, dust and chips using a brush and cloths. Oil moving parts. If compressed air is used for cleaning
remember to wear protective goggles and keep other personnel at a safe distance.
6.2.
Ensure that the motor’s vents are clear at all times.
6.3.
Clean plastic components with water and detergent, never use caustic or abrasive cleaners.
Declaration of Conformity
We, the sole importer into the UK, declare that the product listed below is in conformity with the following
standards and directives.
The construction file for this product is held by the Manufacturer and may
be inspected, by a national authority, upon request to Jack Sealey Ltd.
For Jack Sealey Ltd. Sole importer into the UK of Sealey Quality Machinery.
COMPOUND MITRE SAW
MODEL SM8.V2
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
98/37/EC Machinery Directive
93/68/EEC Marking Directive
Signed by Steve Buckle
24th August 2006
7. DECLARATION OF CONFORMITY
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No responsibility is accepted for incorrect use of this equipment.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your name and address, including postcode.
SM8.V2 - 1 - 240806
01284 757500
01284 703534
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
www.sealey.co.uk
Web
WARNING!
As with all power tools, there are potential hazards involved in the use of this saw. It is, therefore, vital to ensure that
you have read and understood all the safety instructions in Section 1.
Familiarise yourself again with the specific saw safety rules for each step of the following operation. Failure to do so could
cause serious damage and/or personal injury and may invalidate your warranty. Disconnect the saw from the mains power before
making any adjustments or removing/fitting the blade. Ensure that all screws and nuts are secure and that the blade is in good
condition and correctly fitted. ALWAYS wear approved safety eye protection.
5.1.
Set the required table angle and blade angle (see 4.1. & 4.2.). Leave blade in raised position.
5.2.
When you have completed the cut, the waste off-cut will either remain on the saw table and workpiece supports or fall off,
depending upon size. Before starting, therefore, consider how you will handle the off-cut.
5.3.
Plug the saw into the mains power supply.
5.4.
Hold the workpiece securely against the fence.
%
DANGER!
Ensure that your hand cannot come into contact with the blade.
5.5.
Hold the saw handle (fig.1.2) and squeeze the On/Off switch trigger (fig.1.3). When the blade has reached maximum speed press the
release button (fig.1.1) and bring the blade down onto the workpiece.
5.6.
Slowly move the blade down through the workpiece. Do not try to force the blade through the wood, use light pressure only.
5.7.
When the cut is complete allow the blade to rise to the upper position and release the trigger switch to turn off the saw.
!
WARNING!
DO NOT
attempt to pick up an off-cut or to remove a clamped workpiece before the saw blade has completely
stopped.
5. OPERATING INSTRUCTIONS
