InstructIons for:
LOCKERS - 1 DOOR, 2 DOOR, 4 DOOR
MoDEL no's
:
SL1D, SL2D, SL4D
thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
1. SAFETY INSTRUCTIONS
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2. INTRODUCTION
1.1. GENERAL SAFETY
WARNING!
Ensure Health & safety, local authority, and
general workshop practice regulations are adhered to when
using these lockers.
Locate locker in a suitable work area.
Keep the work area clean, uncluttered and ensure there is
adequate lighting.
WARNING!
use locker on level and solid ground, preferably
concrete.
Keep the locker clean and tidy in accordance with good
workshop practice.
Keep children and unauthorised persons away from the work area.
DO NOT
use the locker for any purpose other than that for
which it is designed.
DO NOT
use the locker outdoors.
DO NOT
get the locker wet or use in damp or wet locations or
areas where there is condensation.
DO NOT
clean the locker with any solvents which may damage
the surfaces or the protective coating.
2.1. Introduction:
A range of lockers suitable for a variety of commercial
applications. Single and two door models fitted with a hanging
bar, single door model also has single shelf. Doors on all models
are ventilated and fitted with cylinder locks, 2 sets of keys
supplied per lock. Supplied flat packed.
2.2. Dimensions:
Width: 380mm, Depth: 450mm, Height: 1850mm.
Original Language Version
SL1D, SL2D, SL4D Issue: 1 - 18/02/10
3. ASSEMbLY
3.1.
Lay out the back panel and the two side panels (fig.1). the side
panels have a cut-out at the front (fig.2). Fit the left hand side
panel to the back panel, secure using the bottom and two
middle screws only.
fig.1
fig.2
3.2.
fit the right hand side panel to the back panel, using the three
lower screws only to secure (fig.3).
3.3.
carefully stand the unit up, ensuring that the panels are not
twisted.
fig.3
