6.7.
HYDRAULIC HOSES
6.7.1.
Ensure all hose connections are tight and not damaged.
6.7.2.
Periodically check hoses for leaks, cracks, abrasions or wear.
6.7.3.
Check for pinhole leaks with a piece of paper, cardboard or similar. Wear eye protection and gloves.
DO NOT
USE YOUR HANDS TO LOCATE A LEAK IN A HYDRAULIC LINE.
▲
DANGER!
Compressed fluid, released through a leak is highly pressurised and can penetrate the skin or eyes, causing severe injury.
Seek medical care immediately.
WARNING!
Always relieve the hydraulic pressure in the system before detaching or attaching a hydraulic line to make repairs.
N.B.: NO RESPONSIBILITY IS ACCEPTED FOR INCORRECT USE OF THIS PRODUCT.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK.
DO NOT RETURN JACKS TO US.
Please telephone us on 01284 757500 to obtain the address and phone number of your local agent.
If jack is under guarantee you can also contact your local stockist.
6.8. De-commissioning
If the beam eventually becomes unserviceable, draw off the oil into an approved container and dispose of the jack and the oil
according to local regulations.
7. TROUBLESHOOTING
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
SJBEX200A Issue 1 05/10/21
Original Language Version
© Jack Sealey Limited
PROBLEM
POSSIBLE CAUSE
REMEDY
Jacking beam will not lift load.
1) Release valve not fully closed.
2) Oil level low.
3) Air supply low.
1) Close valve
fi
rmly.
2) Top-up to correct level.
3) Min. requirement 90psi
Jacking beam will not lift smoothly or to full height.
1) Oil level low.
2) Air in hydraulic system.
1) Top-up to correct level.
2) Bleed system.
Jacking beam will not lower completely.
Release valve not su
ffi
ciently open.
Slowly open valve further.
