background image

Original Language Version

© Jack Sealey limited

SdH102   Issue 1  07/11/18

Sealey Group, Kempson Way, Suffolk Business Park, Bury St edmunds, Suffolk. iP32 7Ar

 01284 757500 

 01284 703534 

 [email protected] 

 www.sealey.co.uk

eNVirONmeNt PrOteCtiON

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to 
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely 
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids 
according to local regulations.

Note

: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior 

notice.

important

: no liability is accepted for incorrect use of this product.

Warranty

: Guarantee is 12 months from purchase date, proof of which is required for any claim.

Weee reGulAtiONS

dispose of this product at the end of its working life in compliance with the eU directive on Waste electrical and electronic equipment 
(Weee). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid 
waste authority for recycling information.

Symptom

Potential cause

Possible remedy

Unit does not operate

Is power supply connected?

Insert the plug into an electrical outlet fully and 

securely - check fuse in plug is oK.

Check to see if the water tank is full of water 

i.e. is water level warning light on See 4.5.1.1.

Remove front cover 4.5.1.2.

empty water out of the tank. See 4.5.1.4.

Check to see if the water tank is fitted properly 

in position.

Remove front cover 4.5.1.2. and reposition 

tank.

d

ehumidified volume 

is small

I

s filter dirty / clogged ?

C

lean filter section 5.1.

Check for any obstructions to front and back 

air inlets / outlets of unit.

See section 1.2.

low ambient temp.

Unit does not work below approx 5

o

C.

low ambient humidity.

Unit has reached required level set.

Humidity remains too 

high.

Room size may be too large.

Room size may exceed 12m

3

.

doors and windows may be opened and 

closed frequently.

Keep doors and windows shut during 

operation.

The dehumidifier is used together with a 

kerosene heater which emits water vapour.

Turn heater off.

7.  trOuBleShOOtiNG

  

Содержание SDH102







Отзывы: