8
do not
touch the workpiece as it will be very hot. Allow to cool.
8
do not
operate the soldering gun if damaged.
8
do not
hold the workpiece by hand.
8
do not
allow children to operate the soldering gun.
note:
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision.
2. introduCtion
Comprehensive soldering kit featuring a 30/100W dual powered pistol type soldering gun. Unit is fitted with a boost trigger function
to increase temperature from 120°C to 250°C. Also fitted with an ergonomic handle, LED indicator light, 1.5mtr cable and BS approved
plug. Supplied in rigid storage case with spare soldering tip, soldering wire, solder sucker and metal soldering stand.
3. SpeCifiCation
Model no: ..................................................................Sd250K
n
ett Weight:
................................................................
0.98Kg
Temperature Range: ..................................... 120°C to 250°C
4. operation
4.1.
Assemble the soldering stand and clamp the work securely.
Warning.
ensure that the soldering tip rests on a heat-proof surface.
4.2.
To use the 30W setting, plug the gun into the mains supply without touching the trigger. The gun will heat up rapidly.
4.3.
To use the 100W setting, press the trigger to boost the tip temperature.
do not
depress the trigger for more than 12 seconds, and
allow to rest for a minimum of 48 seconds before depressing again.
4.4.
Wipe off excess solder and allow the gun to cool completely after use before storing in a cool, dry, childproof location.
4.5.
uSing tHe Solder SuCKer.
The solder sucker can be used where a joint has to be unsoldered or where excess solder has been deposited and needs to be
reduced.
4.5.1.
Prime the sucker by pushing the plunger down until it latches. Bring the soldering iron or gun to the joint and melt the solder. As
soon as the solder is liquid place the tip of the sucker into the solder or as close as possible and press the button on the body of the
sucker.
The plunger will rise by spring action to produce a partial vacuum at the tip. Remove the sucker immediately to avoid being in
contact with the hot tip of the soldering iron/gun.
4.5.2.
Empty the excess solder from the body of the sucker by unscrewing the tip and tapping/shaking to dislodge the solder particles.
5. MaintenanCe
5.1.
CHanging tipS
After a prolonged period of service the tip may become pitted and need replacing. Wait till the gun is cool and isolate from the mains.
loosen the cross headed screw from the barrel and remove the old tip (if the tip is stuck, prise out gently with pliers). Replace the tip
and tighten the screw.
5.2.
Avoid allowing solder to accumulate where the tip enters the iron as this may make the tip difficult to remove.
do not
allow solder
deposits to build up on the tip retaining screw as it may prevent a screwdriver fitting into the cross head. loosen the tip retaining
screw periodically and rotate the tip in the gun to prevent it seizing into the body. Use a proprietary tip cleaner/tinner to keep the tip
clean and tinned correctly
S
D250K Issue 2 (HF) 24/09/18
Original Language Version
© Jack Sealey limited
fig.1
