5. BATTERY CHANGE
5.1.
The inflator requires 2 x AAA batteries.
5.2.
If the battery voltage is below 2.6 volts the battery icon will flash continuously until it shuts down. If the battery voltage is below 2.5
volts, the “LO” battery icon appears while the power is on and then shuts down automatically. The batteries must be changed if the
battery icon flashes. See below.
Unscrew the battery cap
Slide the batteries in the inflator with the
Replace the battery cap, don’t overtighten
positive end facing out, out of the
inflator
6. SCALE CHANGE
6.1.
Press and hold the scale change button to activate the display. Once the display is activated press and hold the button for 2 seconds
to change the display scale, see fig.1.
7. OPERATION
WARNING!
To avoid the risk of personal injury, especially to the eyes,
face or skin,
DO NOT
direct the air stream at any person or body parts.
WARNING!
Never exceed the maximum pressure of the tyre.
7.1.
TO READ PRESSURE
7.1.1.
Before each pressure reading fully depress lever and release. Place hold-on
connector squarely and firmly onto tyre valve.
7.1.2.
Check pressure gauge, the digital display will activate once the tyre pressure
is sensed. If no pressure is sensed the display will not turn on. Press trigger to
add air into the tyre, before reading the pressure again.
7.2.
TO INFLATE
7.2.1.
Place hold-on connector squarely and firmly onto tyre valve.
7.2.2.
Fully depress lever for an appropriate period of time and release lever.
7.2.3.
Check pressure gauge and repeat procedure until correct pressure level is
achieved.
7.3.
TO DEFLATE
7.3.1.
Place hold-on connector squarely and firmly onto the tyre valve.
7.3.2.
Depress lever half way, until the air can be heard escaping, for the appropriate
amount of time, and then release the lever.
7.3.3.
Check pressure gauge and repeat procedure until correct pressure level
is achieved.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Sealey Group.
K
empson Way, Suffolk Business Park,
B
ury St. Edmunds, Suffolk.
I
P32 7AR
www.sealey.co.uk
01284 757500
01284 703534
Web
S
A397 | Issue 1 20/11/15
Original Language Version
© Jack Sealey Limited
fig.1
Battery Removal
Refer to Section 5 above.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential
purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s
registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, according to local regulations.
WEEE Regulations
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
