4.8.
couplings
Vibration may cause failure if a quick change coupling is connected directly to the air riveter. to overcome this, connect a leader
hose - sealey model number AH2r or AH2r/38 - to the riveter. A quick change coupling may then be used to connect the leader hose
to the air line recoil hose.(see figs.1 & 2.)
5. preparatiOn FOr use
5.1.
mandrel change
5.1.1.
select from m3 to m12. lock nuts are all the same size for mandrel and anvil.
5.1.2.
Remove anvil and locknut, fig.3.
5.1.3.
Unscrew knurled cover (anticlockwise) and nose pedestal, fig.4.
5.1.4.
Push back the sliding sleeve and unscrew the mandrel, fig.5.
5.1.5.
Select required mandrel as per rivet nut size, push back sliding sleeve and screw in selected mandrel then release sliding sleeve, fig.6.
5.1.6.
screw on knurled cover, nose pedestal, locknut and anvil.
5.2.
mandrel protrusion setting for blind nut
5.2.1.
set the length of the mandrel protruding out of the anvil, according to the blind rivet nut length. undo the locknut and wind the anvil in
or out as required. re-tighten the locknut.
5.2.2.
Never set the mandrel protruding length too long or too short according to the rivet nut to be set, fig.8.
Fig.1
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
Fig.8
Fig.2
sA317 | issue 1 05/12/16
Original Language Version
© Jack sealey limited
