IMPORTANT WARRANTY INFORMATION:
The battery pack fitted to this cordless tool is considered to be a consumable item and its ability to accept charge will reduce over
time. We will warranty it against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear. If the
battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will
not replace the battery pack even if it is less than one year old.
4.1.
BATTERY CHARGING
4.1.1.
Plug the charger into a mains electric socket. When switched on, the charger LED will display a green aspect.
4.1.2.
To release the battery press the battery latch and slide the battery forward.
4.1.3.
Slide the battery into the charger (fig.2). The charger LED will display a steady red aspect to show that charging is taking place.
4.1.4.
When the battery is fully charged, a green aspect will return. Allow the battery to cool before use.
4.1.5.
Replace the battery in the drill, sliding in until secured by the latch.
NOTE:
When new, the battery may have been shipped in a low charge state. It will take longer to charge the battery initially and several
subsequent charges may also take a little longer, compared with when the battery reaches its optimum performance.
4.2.
USING THE DRILL
(fig.1)
4.2.1.
E
nsure that you have read, understood and comply with all the safety instructions in Section 1
4.2.2.
Ensure the direction switch is in the mid (lock) position. Open the chuck and insert the required drill or screwdriver bit.
4.2.3.
Select high or low speed by using the selector on top of the casing (high speed for drilling, low for hammer or screwdriving).
4.2.4.
Select the direction of rotation by means of the forward/reverse selector.
4.2.5.
Select hammer, screw or drill by turning the selector ring.
4.2.6.
If driving screws, set the required torque by means of the torque selector ring. 1 is the lowest torque setting.
4.2.7.
The LED worklight is lit whenever the trigger is depressed.
4.2.8.
When the trigger is depressed, the charge level display is also illuminated. When green, amber and red lights are showing, the
charge level is healthy. As the charge level drops, the indicator lights go out progressively. When just the red light is showing, the
battery requires recharging.
4.2.9.
When finished, remove the bit, clean the drill and bit and replace the drill in its case.
4.2.10. Store in a cool, dry place out of the reach of children.
Original Language Version
© Jack Sealey Limited
S01224.01 Issue 1 28/07/20
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack
Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to
www.sealey.co.uk, email [email protected] or telephone 01284 757500
