QUestIon
answer
How many jump
starts can a fully
charged RoadStart
do before needing to
be recharged?
Between 1 and 20 depending upon
operating factors such as temperature,
general condition of the vehicle, engine type
and size.
Can the RoadStart
be recycled?
Yes, in accordance with national and local
authority regulations.
What is the ideal
in-use storage
temperature
of the RoadStart?
Room temperature. The RoadStart will also
operate at lower temperatures, its power
however will be lessened. Intense heat will
activate self-discharge.
I have a regular 10
amp battery charger,
can I use it to
recharge the
RoadStart?
no. only the supplied charger can be used.
Is the RoadStart fool
proof?
no. All jump starting instructions must be
followed carefully.
Can I replace the
internal batteries?
Yes, but note that the batteries are not
covered by warranty as they are
consumable items
tHe proBLem
tHe soLUtIon
Unit has been charged
for 36 hours but there
is no change in the
status of the leds
Check charger to see that it is charging.
Charger should be warm.
Check all wire connections
Charger works well but
still no change in led
status.
Possible defective internal battery.
no leds come on, but
when the AC adaptor is
plugged into the unit
they do.
RoadStart unit battery defective which
could have been caused by intense use
without a cool-down period.
Roadstart unit is fully
charged but delivers no
power.
Check where the wires meets the jaw on
the unit clamps. ensure they are well
crimped. ensure that the safety switch is
in the on position.
When connecting an
accessory via the dC
outlet there is no
power.
The accessory is drawing too much
current, resulting in the internal circuit
breaker operating. Allow to cool and
reset. Check accessory current draw.
9. troUBLesHootIng
R
S132.V4 Issue 1 11/10/18
Original Language Version
© Jack Sealey limited
sealey group, kempson way, suffolk Business park, Bury st edmunds, suffolk. Ip32 7ar
01284 757500
01284 703534
www.sealey.co.uk
envIronment protectIon
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
weee regULatIons
dispose of this product at the end of its working life in compliance with the eU directive on Waste electrical and electronic equipment
(Weee). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Battery removaL - see sectIon 8
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack
Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.
note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: no liability is accepted for incorrect use of this product.
warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
