10
4.
Turn the USB device on.
5.
Reverse these steps when finished using the USB port.
NOTES: The USB port will shut-off automatically after 60 minutes, if no device is connected. Extended
operation of a USB device may result in excessive battery drain. Recharge the Roadstart® immediately
after unplugging the device.
8. FUSE REPLACEMENT FOR THE ROADSTART®
The Roadstart® is equipped with an inline fuse, to protect the battery from overload.
Fuse Specification:
PBI2212GS Roadstart® 12V:
Fast blow, DC automotive type, rated 32V, 300A (Bussman/Audio Ohm Srl)
Roadstart® PBI4424GS 12/24V:
Fast blow, DC automotive type, rated 32V, 500A (Bussman/Audio Ohm Srl)
Keep away from sparks and flame – battery could emit explosive gases.
1. Allow the fuse to cool down completely (approximately 5 minutes).
2. Make sure the switch is in the OFF position and the unit is unplugged from the
external charger.
3. Remove the positive (RED) clamp from the side of the unit and locate the fuse
holder.
4. Open the fuse holder by removing its cover.
5. Using a wrench, remove the first nut and bolt securing the fuse on the positive
cable. Repeat the same steps for the second nut and bolt. Remove the open fuse
and replace it with a new one of the same type and rating.
6. Tighten the nuts and bolts to secure the fuse, and then replace the cover of the
fuse holder.
7. The unit is now ready to use.
9. MAINTENANCE INSTRUCTIONS
9.1.
Cleaning and user maintenance should not be done by children without supervision.
9.2. Unplug the charger from the booster before attempting any maintenance or cleaning.
9.3. Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clamps, cords
and the Roadstart® case. Do not use cleaning fluids.
9.4. Ensure that all of the Roadstart® components are in place and in good working condition.
9.5. All other servicing should be performed by qualified service personnel.
9.6.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons, in order to avoid a hazard.
10. MOVING AND STORAGE INSTRUCTIONS
10.1. Store the Roadstart® in an upright position, inside, in a cool, dry place.
10.2. Always make sure the booster is fully charged before storing.
When not in use, it is highly recommended to leave the booster on charge.
Do not use and/or store the Roadstart® in or on any area or surface where damage
could occur if the internal battery should unexpectedly leak acid.
/!\ WARNING
IMPORTANT
