5. MAINTENANCE
IMpORTANT:
Only fully qualified personnel should attempt maintenance or repair.
5.1.
When the jack is not in use, the saddle must be in it's lowest position to minimise ram and piston corrosion. Turn the handle back to
it's storage position for safety.
5.2.
Keep the jack clean and wipe off any oil or grease. Lubricate all moving parts with acid free oil, and grease tilt mechanism regularly.
5.3.
To check the hydraulic oil level, fully lower the jack and the handle and remove the oil filler plug on top of the cylinder. The correct oil
level shouid be just below the filler opening. If oil level is low, fill as required. Make sure that dirt is not allowed to enter the hydraulic
system. carefully pump unloaded jack 5 or 6 times to expel any air and then refit oil filler plug.
NOTE:
Only a good quality Jack oil, such as SEALEy hyDRAuLIC JACK OIL must be used, DO NOT use brake fluid, or any
other fluid, other than hydraulic jack oil, as this may cause serious damage to the jack and will invalidate the warranty.
5.4.
Before each use check list to ensure components are not damaged, broken, cracked, bent, malfunctioning, distorted, worn, loose,
leaking, dirty, noisy or missing and that welds are not visibly damaged (see Section 3.1). If any suspect item is found, remove jack
from service immediately and take necessary action to remedy the problem and/or contact your authorised service agent.
DO NOT use the jack if it is believed to have been subjected to abnormal load or shock. Inspect and take appropriate action.
5.5.
Periodically check the pump piston and piston rod for signs of corrosion. clean exposed areas with a clean oiled cloth.
IMpORTANT:
NO RESpONSIBILITy IS ACCEpTED FOR INCORRECT uSE OF ThE MAChINE.
`
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK.
DO NOT RETuRN
JACKS TO uS. Please telephone 01284 757500 to obtain address and telephone number of your local agent. If Jack is under
guarantee please contact your dealer.
De-commissioning the jack: Should
the jack become completely unserviceable and require disposal, draw off the oil into an
approved container and dispose of the jack and the oil according to local regulations.
PROBLEM
CAUSE
SOLUTION
Jack will not lift.
Jack will only lift halfway.
Raised load will not hold.
Poor lifting.
Saddle tilt knob too tight.
No hydraulic oil or defective suction valve, delivery valve or
release valve is open.
Hydraulic oil level low.
Defective valves or defective piston packing.
Defective plunger packing.
Bolts and nuts may be bent or rusted.
contact authorised service agent.
close delivery valve.
Refill (see section 5.3. above).
contact authorised service agent.
contact authorised service agent.
check, clean, oil or replace items.
6. TROUBLESHOOTING
IMPORTANT!
Although the following may identify a problem, in most cases the problem must be resolved by your authorised service agent.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
Original Language Version
TJ1000F, TJ1500F ISSUE No:1 - 05/01/10
Parts support is available for this product.
To obtain a parts listing and/or diagram, please log on to www.sealey.co.uk, email [email protected] or phone 01284 757500.
