5.6.
reFillinG anD usinG DeTerGenT
5.6.1.
Adjusting the spray pattern. Water flow is adjusted by twisting
the nozzle (fig.5).
5.6.2.
Adjusting the detergent to deliver detergent at the correct
pressure, set the nozzle (fig.6) (where fitted) on “ “ or fit
the detergent kit (fig.7.C13) as shown. The quantity
of detergent delivered is adjusted using the regulator (fig.7)
5.6.3.
The detergent must be delivered using the accessories and
by the procedures described in point 5.9. Use of a high
pressure hose longer than the one originally supplied with
the appliance, or the use of an additional hose extension, may
reduce or completely halt the suction of detergent. Fill the
tank (fig.7) with highly biodegradable detergent.
5.7.
sealey DeTerGenTs:
TFr Premium Detergent with Wax Concentrated 5ltr ...sCs001
TFr Detergent with Wax Concentrated 5ltr ...................sCs003
Car shampoo 5ltr ............................................................sCs005
Car shampoo Premium with Wax 5ltr ............................sCs006
5.8.
reCoMMenDeD CleaninG ProCeDure
5.8.1.
dissolve dirt by applying the detergent mixed with water to
the surface while still dry. When dealing with vertical
surfaces work from the bottom upwards. leave the detergent
to act for 1-2 minute but
Do noT
allow the surface
to dry. Starting from the bottom, use the high pressure
jet at a minimum distance of 30 cm.
Do noT
allow the rinse
water to run onto unwashed surfaces. In some cases, scrubbing with brushes is needed to remove dirt. High pressure is not always
the best solution for good cleaning results, since it may damage some surfaces. The finest adjustable nozzle jet setting or the rotating
nozzle should not be used on delicate or painted parts, or on pressurised components (e.g. tyres, inflation valves, etc.). Effective
cleaning depends on both the pressure and volume of the water used, to the same degree.
6. MainTenanCe
Any maintenance operations not covered by this chapter should be carried out by an Authorised Sales and Service Centre.
Warning
Always disconnect the plug from the power socket before carrying out any work on the appliance.
6.1.
CleaninG The nozzle (FiG.8)
1) disconnect the lance from the nozzle.
2) Remove any dirt deposits from the nozzle hole using the tool
(fig.16.C1).
6.2.
CleaninG The FilTer (FiG.9)
Inspect the inlet filter (fig.9.L) and detergent filter (if fitted) before
each use, and clean in accordance with the instructions
if necessary.
6.3.
sToraGe
1) Turn off the water supply tap.
2) discharge the residual pressure from the gun until all the water
has come out of the appliance.
3) Switch the appliance off (OFF/0).
4) Remove the plug from the socket.
5) Drain and wash out the detergent tank at the end of the working
session. To wash out the tank, use clean water instead of the
detergent.
6) Engage the gun safety catch (fig.6.D).
6.4.
enD-oF-season sToraGe
6.4.1.
Treat the appliance with non-corrosive, non-toxic antifreeze before
storing it away for winter. Put the appliance in a dry place, protected
from frost.
fig.7
fig.8
fig.9
P
WTF2200 Issue 1 20/12/18
Original Language Version
© Jack Sealey limited
