3 DRAWER HEAVY DUTY HANG-ON LOCKER
MODEL NO:
PTB39003.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this locker.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the locker clean and tidy in accordance with good workshop practice.
8
DO NOT
use the locker for any purpose other than that for which it is designed.
8
DO NOT
step on the shelves or drawers.
8
DO NOT
overload the locker.
8
DO NOT
clean the locker with any solvents which may damage the surfaces or protective coating.
2. INTRODUCTION
Textured powder coat finish, both solvent and rust resistant. Ball bearing drawer slides provide superior performance and carry heavier loads,
double sets on large drawers. All drawers have full width sand blasted aluminium ‘Lift & Latch’ drawer pulls, making easy-access while preventing
inadvertent opening when being moved. Non-slip drawer liners supplied for all drawers. Integral locking system locks all drawers with the turn of 1
key. Supplied with 2 keys. Hang-On locker suitable for heavy-duty Premier rollcabs. Heavy duty welded steel construction for strength and durability.
SPECIFICATION
Model No. ............................................................. PTB39003
Overall size (W x D x H) ........................390 x 460 x 1390mm
No. of Drawers .....................................................................3
No. of Shelves......................................................................2
3. CONTENTS
PTB39003.V2 Issue 1 25/11/20
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Wear protective
gloves
fig.1
ITEM
DESCRIPTION
QTY
1
M6 x 16 Hex bolt
3
2
Connecting piece
1
3
M6 x 16 c/sink screw
4
4
Hangar
1
5
Magnet
3
6
EVA Pad
2
7
Slide set
3 sets
8
Drawer liner
3
9
Shelf support
8
10
Lock
1
11
Shelf liner
3
