INSTRUCTIONS FOR:
1/2”Sq DR G3 AIR
IMPACT WRENCH
MODEL No:
GSA01
For recommended hook-up, procedure is shown in fig 1 & 2
3.1. Air Supply
3.1.1. Ensure wrench air valve (or trigger) is in the "off" position before connecting to the air
supply.
3.1.2. You will require an air pressure of 90psi, and an air flow according to specification.
3.1.3.
WARNING!
Ensure the air supply is clean and does not exceed 90psi while operating the
wrench. Too high an air pressure and unclean air will shorten the product life due to
excessive wear, and may be dangerous causing damage and/or personal injury.
3.1.4. Drain the compressor air tank daily. Water in the air line will damage the wrench.
3.1.5. Clean compressor air inlet filter weekly.
3.1.6. Line pressure should be increased to compensate for unusually long air hoses (over 8
metres). The minimum hose diameter should be 1/4” I.D. and fittings must have the same
inside dimensions.
3.1.7. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain
that all connections are secure.
3.2. Couplings.
Vibration may cause failure if a quick change coupling is connected directly to the wrench. To
overcome this, connect a leader hose to the wrench. A quick change coupling may then be used
to connect the leader hose to the air line recoil hose. See fig 1 & 2.
3.
PREPARING WRENCH FOR USE
4. OPERATING INSTRUCTIONS
WARNING! Ensure you read, understand and apply safety
instructions before use.
4.1.
Only use impact sockets which are specifically designed for
use with an impact wrench.
4.2.
Connect the wrench to the air hose as in Section 3.
4.3.
Place the socket over the subject nut and depress the trigger to
operate the wrench.
4.4.
To change drive direction turn the air regulator on the rear of
the body to the desired direction. (fig 3)
4.5.
The flow of air may be regulated by adjusting the air regulator
on the rear of the body, between 1 low power and 3 full power.
DO NOT
use any additional force upon the wrench in order to
remove a nut.
DO NOT
allow wrench to free run for an extended period of
time as this will shorten its life.
fig 1
fig 2
fig 3
Original Language Version
Jack Sealey Limited 2013
GSA01 Issue: 4 (SP) - 05/09/13
