3.2.7.
undo and remove the stop.
3.2.8.
insert the sAe oP1 end punch and tighten fully up to the hexagon in
order to form the flare.
3.2.9.
unscrew the punch. the single flare is now complete.
3.2.10. undo the locking screws and remove the tool from the pipe.
3.3.
creatiOn Of 3/16” sae DOuble flare
3.3.1.
follow steps in 3.1 above to form a single flare.
3.3.2.
reverse the punch and insert the sAe oP2 end into the tool and fully
tighten up to the hexagon in order to form the flare.
3.3.3.
unscrew the punch.
3.3.4.
undo the locking screws and remove the tool from the pipe. the
double flare is now complete.
3.4.
creatiOn Of a 4.75mm Din flare
3.4.1.
use the din tool and din punch as shown in fig.1.
3.4.2.
follow steps 3.2.1 to 3.2.7. to set the pipe length.
3.4.3.
insert the din punch and tighten fully to form the flare.
3.4.4.
unscrew the punch.
3.4.5.
unscrew the locking screws and remove the tool from the pipe.
note:
After completing a flare, check that it has been correctly formed
using the gauge in the end of the 3/16” stop. if the flare goes into the bore
it is undersized and will need to be redone. this may be due to the pipe
being pushed back during the flare process.
Pft11.V3 | issue 1 11/07/18
Original Language Version
© Jack sealey limited
fig.1
sealey group, kempson Way, suffolk business park, bury st edmunds, suffolk. ip32 7ar
01284 757500
01284 703534
www.sealey.co.uk
envirOnment prOtectiOn
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note
: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important
: no liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Parts support is available for this product. Please email [email protected] or telephone 01284 757500