3. ASSEMbLY / PRE-OPERATION
Unpack contents and check to ensure all parts are in good
condition. If you experience any problems contact your
dealer immediately.
3.1 ASSEMbLY.
3.1.1 Screw together the two halves of the lance as shown in fig.5.
Slide the rubber cover over the connector nut.
3.1.2 Attach the high pressure hose to the water inlet on the
gun handle as shown in fig.3A and B.
3.1.3 Attach the other end of the high pressure hose to the
pump outlet as shown in fig.2.
3.1.4 Connect the mains water supply hose to the pump inlet
as shown in fig.2.
Note:
The water supply hose must be reinforced and have an
internal diameter of 13mm (1/2”). The minimum water
supply rate must be at least equal to the washer flow
rate.
3.2 DETERGENT DELIVERY.
3.2.1 On the side of the pump outlet is a brass siphon injection
fitting. Push the detergent delivery pipe onto the fitting
and place the filter on the other end into a container of
detergent (fig.2). When the nozzle on the lance is set to
low pressure, detergent will be drawn from the container
by siphonic action and will mix automatically with the
water from the pump. Use Sealey General Purpose
Detergent,
AK130 (25ltr)
or
AK131 (5ltr)
. Traffic Film
Remover is also available,
AK132 (25ltr)
or
AK133 (5ltr)
.
3.3 NOZZLE CONTROL.
3.3.1 PRESSURE. To change from high pressure to low
pressure the whole nozzle moves backwards and
forwards by about 6mm on the end of the lance. Pull the
nozzle back towards the handle for high pressure and
push it away from the handle for low pressure (see fig.5).
3.3.2 SPRAY PATTERN. To change the spray pattern from a
pencil jet to a fan jet rotate the nozzle as shown in fig.4
3.4 ENGINE LUbRICATION.
3.4.1 The pressure washer engine is shipped from the factory
without oil. Do not attempt to start the engine before the
sump has been filled with the correct amount of oil. Refer
to the section 7.2.
3.5 FUEL.
3.5.1 Fill the petrol tank with fresh unleaded petrol.
fig.1
fig.5
fig.4
fig.2
fig.3
Introduction
:
Petrol powered pressure washer with recoil starting. Suitable
for commercial and domestic applications with 5mtr pressure
hose, gun, lance and adjustable nozzle. Low-pressure liquid
detergent injection system. Safety latch on trigger and
automatic low-oil engine shutdown reduce risks of misuse and
equipment damage. Unit stands on four sucker feet to prevent
creep, and has integral handle. Supplied with tools and full
Instructions.
Original Language Version
PCM1300.V2 Issue: 1 - 08/06/10
