5. ASSEMBLY
CARTON CO
5.1.
ASSEMBLY (fig.2, fig.3, fig.4, )
WARNING:
Ensure no battery is connected (fig.8).
5.1.1.
Undo head assembly clasps and lift off head assembly (fig.3).
5.1.2.
Invert tank body and insert push-fit castors.
5.1.3.
Place the appropriate filter assembly onto tank body (see sections 6 for wet and dry vacuuming and blowing).
5.1.4.
Align up the top section with the clasps and snap into place, by applying pressure at the mid point of the clasps (fig.3).
Insert the large end of the hose into the front inlet of the container and lock in place by turning counter-clockwise a quarter turn (fig.4).
5.1.5.
Choose the desired extension tubes and nozzle and connect onto the hose.
6. OPERATION
WARNING!
Ensure you read, understand and apply Section 1 ‘Safety Instructions’. Reminder:
DO NOT
vacuum hazardous substances.
Use of an incorrect filter will invalidate your warranty.
6.1.
DRY VACUUMING (fig.5)
6.1.1.
Ensure the battery is removed from the unit.
6.1.2.
Loosen clips (fig.3) and remove the top section and filter assembly (fig.7).
6.1.3.
Slide the bag filter inlet hole over the hose connector. Manipulate to ensure a good seal (fig.5).
Original Language Version
© Jack Sealey Limited
PC20SD20V Issue 1 22/02/19
fig.2
fig.3
fig.4
fig.5
fig.6
