Original Language Version
PC195SD Issue No.1 24/07/14
© Jack Sealey Limited
fig.5
6.4.
Verify that the switch is in the ‘O’ position before plugging in the mains cable (Fig.4.4).
6.5.
Turn the motor on by flipping the switch to the “I” position (Fig.4.5).
6.6.
After use, flip the switch to the “O” position and unplug the power cord (Fig.4.6), then empty and dry the container (Fig.4.7).
Remember!
The foam filter must be removed after wet vacuuming, and a dust filter must be installed
before dry vacuuming again.
WARNING!
Always wear safety goggles before using the blower. Keep bystanders away from blowing debris and wear a dust mask if
blowing creates dust that might be inhaled.
7.1.
Insert the large end of the hose into the blower connection in the top of the motor housing (Fig.5.1).
7.2.
Fit the desired nozzle to the vacuum hose (Fig.5.2).
7.3.
Ensure the power switch is turned off and plug in (Fig.5.3).
7.4.
Turn the motor on by flipping the switch to the “I” position (Fig.5.4).
7.5.
The unit will now blow through the vacuum hose and can be used to clear obstructions within the hose (Fig.5.5).
WARNING!
If the hose is still blocked after a few seconds, turn off the unit and clear the hose manually.
8.1.
Verify that the power cable is disconnected (Fig.6.1).
8.2.
Disconnect the hose from the container (Fig.6.2).
8.3.
Undo the clasps and remove the top section from the container (Fig.6.3).
8.4.
Clear all dirt or debris from the container and hose (Fig.6.4).
8.5.
Clean the foam filter or dust filter by washing it with a mild soapy solution (Fig.6.5).
8.6.
Check the hoses, attachments, and power cord to verify that they have not been damaged (Fig.6.6).
IMPORTANT!
Change the dust filter regularly.
IMPORTANT!
If the machine is used without the dust filter, the motor will burn out and the warranty will be voided. Always keep spare
filters on hand.
IMPORTANT!
When vacuuming large quantities of liquids, do not immerse the nozzle completely in the liquid; leave a gap at the tip of the
nozzle opening to allow air inflow. The machine is fitted with a float valve that stops the suction action when the container reaches its maximum
capacity. You will notice an increase in motor speed. When this happens, turn off the machine, disconnect from the mains, and drain the liquid
into a suitable receptacle or drain. To continue vacuuming, refit the container with the container. After wet vacuuming, turn the machine off and
remove the plug. Empty the container, clean and dry the inside and outside before storage.
7. BLOWER OPERATION
8. MAINTENANCE
fig.6
