3. SPECIFICATION
Model No ...........................................................
LED108C.V3
Battery ........................................................Li-ion 7.4V 2.2Ah
Lumen Output ..............................................................
585lm
LEDs ................................................................................
108
Operating Time ..............................................................
3.5hr
Charging time ....................................................................4hr
4. OPERATION
WARNING!
Ensure that you read, and fully understand the safety instructions before use.
4.1.
BATTERY CHARGING
4.1.1.
Ensure the floodlight is turned ‘Off’ whilst charging. Failure to do so will damage the charger plug/vehicle plug
4.1.2. Turn floodlight ‘On’ and ‘Off’ by the rocker switch (fig.1.A) on the main body. Select position ‘O’ to turn the floodlight ‘Off’.
4.1.3. The position of the main body can altered by loosening the thumb screws (fig.1.B) and moving the main body.
4.2.
MAINS CHARGER PLUG
4.2.1.
Ensure the floodlight is turned ‘Off’ and then plug the charger adaptor into the jack inlet (fig.1.C) on the floodlight body. Stand the
floodlight in a safe location ready to charge.
4.2.2. Plug charger into the mains supply. The charging indicator LED (fig.2) will illuminate RED as the battery charges.
4.2.3. Allow approximately 4hours for the initial charge and for subsequent charges. Once the battery has reached full charge, the charging
indicator LED (fig.2) will illuminate GREEN.
4.2.4. When full charge has been reached, switch off the mains supply and unplug the charger from the mains and then from the floodlight.
The floodlight is now ready for use.
4.2.5.
Store the charger in a safe, dry location.
Notes: a) Fully charged batteries will last for approximately 3.5hours.
b)
DO NOT
fully discharge the batteries before recharging.
c)
DO NOT
leave batteries in a discharged state, recharge batteries immediately. If the floodlight is not in use, recharge
the batteries every three months.
4.3.
VEHICLE CHARGER PLUG
4.3.1.
Ensure the floodlight is turned ‘Off’ and then plug the vehicle charger plug into the jack inlet (fig.1.C) on the floodlight body.
Stand the floodlight in a safe location ready to charge.
4.3.2. Insert the charger plug into the vehicle’s accessory socket (12V only). The charging indicator LED (fig.2) will illuminate RED as the
battery charges.
4.3.3. Allow approximately 4hours for the initial charge and for subsequent charges. Once the battery has reached full charge, the charging
indicator LED (fig.2) will illuminate GREEN.
4.3.4.
When full charge has been reached, unplug the adaptor from the vehicle’s accessory socket and then from the floodlight. The
floodlight is now ready for use.
4.3.5.
Store the charger plug adaptor in a safe, dry location.
NOTE:
Charging the floodlight from a 12V vehicle socket will drain the vehicle’s battery, unless the engine is running.
NOTE:
The Li-ion battery does not suffer from memory effect and once fully charged the floodlight may be stored for up to 6 months
before recharging is required.
IMPORTANT WARRANTY INFORMATION:
The battery fitted to this floodlight is considered to be a consumable item and its ability to accept charge will reduce over time. We will
warranty it against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear. If the battery is not
properly charged before first use, or properly conditioned its capacity will diminish. Under these circumstances we will not replace the
battery even if it is less than one year old.
fig.1
Original Language Version
© Jack Sealey Limited
L
ED108C.V3 | Issue:1 21/05/18
fig.2
fig.3
