4.1.3. to use the lamp, plug the transformer plug into the mains socket to turn the light on.
4.1.4. When finished, disconnect the transformer plug from the mains supply and store the lamp in a safe, dry and childproof location.
4.1.
ATTACHING LAMP TO BONNET.
4.1.1. Place the padded hook at the end off the lamp, over one edge of the bonnet, and gently pull the lamp towards the other side of the
bonnet.
4.1.2. steady the lamp with one hand, whilst extending the hook over the other side of the bonnet.
5.1.
Keep lamp clean and check for damage before every use. If damage is observed remove from use until unit is repaired.
LED033.V2 Issue: 1 - 24/02/14
Environmental Protection.
recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
WEEE Regulations.
Dispose of this product at the end of its working life in compliance
with the Eu Directive on Waste Electrical and Electronic Equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. contact your local solid waste
authority for recycling information.
robust design with built-in spring loaded telescopic mounting brackets. soft padded hooks provide good protection against bonnet. 30 sMD
LEDs and angled PcB give complete engine bay illumination with 120°. supplied with 5mtr cable and transformer plug, reducing down to 12V
for added safety.
2. INTRODUCTION
3. SPECIFICATION
4. OPERATION
5. MAINTENANCE
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
no liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park
,
Bury st. Edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Original Language Version
© Jack sealey Limited
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LED033.V2
Voltage: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 230V
Power: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12W
Minimum/Maximum Bonnet Width: . . . . . . . . . . 1230/3528mm
Lamp type: . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 x 3528 sMD
Parts support is available for this product. to obtain a listing and/or diagram, please log on to: www.sealey.co.uk,
email: [email protected] or phone: 01284 757500
