InstructIons for:
UNDER BONNET LAMP 30 SMD & 230V TRANSFORMER
MoDEL no:
LED033.V2
1.1. GENERAL
WARNING!
Disconnect lamp from mains power before performing any maintenance.
DO NOT
shine lamp directly into your, other person’s or animal’s eyes.
DO NOT
allow children to use the lamp.
Maintain the lamp in good condition.
DO NOT
use the lamp if the lamp if damaged.
When not in use store the light in a safe, dry, childproof location.
WARNING!
Ensure Health and safety, local authority and general workshop practice regulations are adhered to when using this light.
Wear eye protection. A full range of safety equipment is available from your sealey dealer.
Wear suitable clothing to avoid snagging.
DO NOT
wear jewellery and tie back long hair.
Account for all tools being used and
DO NOT
leave them in or near the engine.
1.2. ELECTRICAL SAFETY FOR USE OF TRANSFORMER. USE ONLY THE SUPPLIED TRANSFORMER PLUG FOR CONNECTING LAMP
TO THE POWER SUPPLY.
WARNING!
It is the user’s responsibility to read, understand and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices. An rccB (residual current circuit
Breaker) should be incorporated in the main distribution board. We also recommend that an rcD (residual current Device) is used with all
electrical products, particularly portable equipment which is plugged into an electrical supply not protected by an rccB.
You must
also read and understand the following instructions concerning electrical safety.
1.2.1.
The Electricity At Work Act 1989
requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance tester (PAt), at least once a year
.
1.2.2. The Health & Safety at Work Act 1974
makes owners of electrical appliances responsible for the safe condition of the appliance and the
safety of the appliance operator.
If in any doubt about electrical safety, contact a qualified electrician.
1.2.3. You must ensure that you:
Inspect the transformer plug, cable and connector for wear and damage to ensure items are safe before connecting to the mains power supply.
If worn or damaged
DO NOT
use.
Important: check that the voltage marked on the transformer plug is the same as the power supply to be used.
uncoil the cable between transformer plug and lamp.
DO NOT
pull the transformer plug from the mains socket by the lead.
DO NOT
use any other type of transformer with this product.
DO NOT
try to take the transformer plug apart.
DO NOT
use the transformer plug to power any other electrical item.
DO NOT
get the transformer plug wet, or use in wet, damp conditions (for indoor use only).
WARNING!
NEVER
substitute a standard 13amp 3 pin plug, or any other type of plug, for the transformer plug.
this transformer plug reduces and rectifies the mains voltage (230 volts Ac) to
12 volts DC.
WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which must be applied by the operator.
Original Language Version
LED033.V2 Issue: 1 - 24/02/14
thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly
maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
© Jack sealey Limited
