Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. GENERAL
Ensure the lamp is fully charged before initial use.
DO NOT
turn the lamp on when it is being charged.
DO NOT
shine directly into your, other person’s or animal’s eyes.
DO NOT
allow children to use the lamp.
DO NOT
handle or move the lamp whilst it is being charged.
DO NOT
use the lamp if you suspect that the battery or the lamp casing is damaged.
DO NOT
leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery,
subsequently recharge the battery at least once every six months of non-use.
1.2. ELECTRICAL SAFETY FOR USE OF CHARGERS.
USE ONLY THE SUPPLIED CHARGER PLUGS FOR CONNECTING LAMP TO THE POWER SUPPLY.
WARNING!
It is the user’s responsibility to read, understand and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.
An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that
an RCD (Residual Current Device) is used with all electrical products, particularly portable equipment which is plugged into
an electrical supply not protected by an RCCB.
You must
also read and understand the following instructions concerning electrical safety.
1.2.1.
The Electricity At Work Act 1989
requires all portable electrical appliances, if used on business premises, to be tested by
a qualified electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.2.2.
The Health & Safety at Work Act 1974
makes owners of electrical appliances responsible for the safe condition of the
appliance and the safety of the appliance operator.
If in any doubt about electrical safety, contact a qualified electrician.
1.2.3.
You must ensure that you:
Inspect the charger plugs, cables and connectors for wear and damage to ensure items are safe before connecting to the
mains power supply or 12V accessory socket. If worn or damaged
DO NOT
use.
Important: Check that the voltage marked on the charger plug is the same as the lamp.
Uncoil the cable between charger and the lamp.
DO NOT
pull the charger plugs from the mains socket or 12V accessory socket by the lead.
WARNING! DO NOT use any other type of charger with this product, other than the supplied mains or car
charger. Failure to observe this warning could result in injury and or fire and will invalidate the warranty.
DO NOT
try to take the chargers apart.
DO NOT
use the charger plug to charge or power any other electrical item.
DO NOT
get the chargers wet, or use in wet, damp conditions (for indoor use only).
1.3. BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
DO NOT
attempt to open, disassemble, modify or service the battery pack.
DO NOT
crush, puncture, short external contacts or dispose of in fire or water.
DO NOT
expose to temperatures above 60°C (140°F).
Replace only with the battery pack designated for this product.
Recycle or dispose of used battery as stipulated by local regulation.
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly
with cool water and seek immediate medical attention.
Soft touch composite casing features 37 super bright LEDs. 30 LEDs used as an inspection lamp or 7 LEDs for use as a
directional torch. Fitted with single LED battery indicator. Two 360° swivel hanging hooks for hands free applications.
Two magnets, one on rear of lamp and one on the end. Lower quarter of lamp rotates 180°. Supplied with mains charger and
in-car charger.
Battery: ..............................................................3.6V / 1200mAh
Charging Time: .................................................................. 3.5hrs
Operating Time: .................................................................... 5hrs
Length..............................................................................280mm
2. INTRODUCTION / SPECIFICATION
INSTRUCTION MANUAL FOR:
CORDLESS 30 + 7 LED RECHARGEABLE
INSPECTION LAMP
MODEL No.
LED024
Original Language Version
LED024 Issue: 2 - 12/10/11
