5. ASSEMBLY
NOTE:
The stando
ff
frame is supplied with the brace (#2) and the spring (#5) attached.
5.1.
ATTACHING THE HOOKS
NOTE:
The lower hooks (#4), M6 x 25mm bolt (#8), M6 flat washer (#9) and the M6 hex nut (#10) are supplied attached to the hook
brackets
(#3).
Also
the upper hooks (#4), M6 x 35mm bolt (#6), M6 x 30mm bolt (#7), M6 flat washer (#9) and the M6 hex nut (#10) are supplied
loosely assembled to the hook brackets (#3).
5.1.1.
On the upper hook (#4) and the hook brace (#3), undo and remove the M6 flat washer (#9) and the M6 hex nut (#10) from the
M6 x 35mm bolt (#6), and the M6 x 30mm bolt (#7) leaving the bolts within their fixing holes.
5.1.2.
Locate the upper hook (#4), hook bracket (#3), M6 x 35mm bolt (#6) and the M6 x 30mm bolt (#7) with the corresponding holes on
the brace (#2).
5.1.3.
Refit
the M6 flat washer (#9) and M6 hex nut (#10) to the M6 x 35mm bolt (#6) and the M6 x 30mm bolt (#7) and fully tighten.
5.1.4.
Repeat for the other hook (#4).
6.
OPERATION
6.1.
ATTACHING 2 WAY LADDER STANDOFF TO A LADDER
6.1.1.
Place the 2 way ladder stando
ff
assembly over the top rungs of the ladder (
fi
g 1).
6.1.2.
Secure into position by gripping onto the springs handle loop whilst pulling down on the spring until it locks into position around the
ladder rung (
fi
g 1).
6.2.
REMOVING 2 WAY LADDER STANDOFF FROM LADDER
6.2.1.
Grip onto the springs handle loop and pull down until the spring is below the ladder rung, and then swing outwardly, then carefully
allow the spring to fully retract.
6.2.2.
Remove from the ladder and store the 2 way ladder stando
ff
in it’s original packaging in a safe, dry, childproof location.
WARNING!
Be aware of the strength of the spring. Care should be exercised when extending or releasing the spring as an
uncontrolled release may cause personal injury.
7. MAINTENANCE
7.1.
Periodically check that all
fi
xings are tight and secure.
7.2.
Check that the rubber pads are in good condition and not worn.
8. CLEANING
8.1.
Clean with a damp cloth.
DO NOT
use solvents to clean the 2 way ladder stando
ff
.
LAD004 Issue 2 (H,F) 01/11/21
Original Language Version
© Jack Sealey Limited
fi
g.1
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
