background image

3. OPERATING INSTRUCTIONS

4. MAINTENANCE

3.1.

ATTACHING PULLER TO LOAD AND THE ANCHOR.

p

WARNING! Ensure you have read, understood and

apply chapter 1 safety instructions before using the puller.

3.1.1. Secure hook and pulley to a rigid anchor which will take the 

strain of the load to be pulled.

3.1.2. Secure the puller to the load to be pulled.

3.1.3. Depress the drive pawl spring in the direction of arrow 

in figure 1. A.

3.1.4. Raise handle and hold firmly in this position, then depress stop 

pawl in the direction of arrow “B”.

3.1.5. At the same time pull until desired slack has been taken up

between the anchor, puller and the load.

fig 1

3.3.

TO RELEASE THE TENSION

p

WARNING! Avoid abrupt handle movements, apply 

pressure to handle with an even and steady force.

3.3.1. Depress the pawl spring in the direction of arrow in figure 3. A.

3.3.2. Very carefully and slowly push handle until drive pawl pushes

and disengages the stop pawl (not shown) to clear ratchet 

teeth. This will release the load by one notch.

3.3.3. Repeat this handle motion as required to release the tension 

one notch at a time.

3.3.4. When the tension has been fully released, check the load and 

anchor to determine removal of the pulley hooks.

4.1.

CABLE REPLACEMENT.

A special quick-change designed “Keyhole” and a swayed end opening in the barrel of the ratchet wheel permits instant and secure 

replacement of the cable.
1. Pull all the cable off the ratchet wheel.

2. ”Snap” old cable out of the “Keyhole”.

3.  “Snap” the new cable into the “Keyhole”.

4.  Rewind the cable onto the ratchet wheel.

4.2.

CLEANING

Clean the puller after each use, and wipe the tool with a slightly oiled cloth, then store in a safe, dry, childproof place.

fig 3

3.2.

APPLY TENSION

p

WARNING! Do Not overload.

3.2.1. Engage the drive pawl and ratchet wheel by pushing pawl 

spring in the direction of arrow figure 2.A.

3.2.2. Each pull of the handle will wind the cable to pull the load.

fig 2

Sole UK Distributor

Sealey Group,

Bury St. Edmunds, Suffolk.

01284 757500

E-mail:

[email protected]

01284 703534

NOTE:

It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.

IMPORTANT: 

No liability is accepted for incorrect use of product. 

WARRANTY: 

Guarantee is 12 months from purchase date, proof of which will be required 

for any claim. 

INFORMATION: 

Call us for a copy of our latest catalogue on 01284 757525 and leave your full name and address including your postcode.

HP700-1000-1500  (0016) -(3) - 010700

Declaration of Conformity 

We, the sole importer into the UK, declare that the products listed here

are in conformity with the following EEC standards and directives

The construction files for these products are held by the Manufacturer and may be inspected on request 

by contacting Jack Sealey Ltd

For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products

HAND POWER PULLERS Models HP700,

HP1000, HP1500.

EC Machinery Directive 98/37/EC

25th November 1999

Signed by Mark Sweetman

Отзывы: