12V 3/8”SQ DRIVE CORDLESS IMPACT WRENCH
80NM - BODY ONLY
MODEL NO:
CP1204
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Maintain the Impact Wrench and battery in good condition. Check moving parts alignment on a regular basis.
9
Replace or repair damaged parts. Use an authorised service agent and recommended parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
9
Ensure the Impact Wrench is switched off before installing the battery pack.
9
Keep the Impact Wrench and charger clean for best and safest performance.
9
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain long hair.
9
Evaluate your working area before using the Impact Wrench; e.g. ceilings, floors and enclosures may contain electrical items or
water piping
9
Ensure battery pack is correctly inserted into the Impact Wrench handle and latched in place before attempting to switch on Impact
Wrench.
9
Secure loose work pieces with a clamp, vice or other adequate holding device.
9
Avoid unintentional starting.
9
Wear approved safety eye protection (standard spectacles are not adequate).
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-skid shoes.
9
Be aware that this Impact Wrench does not need to be plugged into the mains power.
9
Keep direction switch in the locked position until the Impact Wrench
is required for use.
9
Keep children and unauthorised persons away from the working area.
8
DO NOT
use the Impact Wrench where there are flammable liquids, solids or gases, such as paint solvents, etc.
8
DO NOT
allow children to operate the Impact Wrench.
8
DO NOT
operate the Impact Wrench
if any parts are missing as this may cause failure and/or personal injury.
8
DO NOT
hold unsecured work piece in your hand.
8
DO NOT
leave the Impact Wrench operating unattended.
8
DO NOT
carry the Impact Wrench with your finger on the power switch. Keep direction switch in the locked position.
8
DO NOT
use the Impact Wrench for a task it is not designed to perform.
8
DO NOT
operate the Impact Wrench
when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT
get the Impact Wrench or battery charger wet or use in damp or wet locations.
2. INTRODUCTION
C
ompact, lightweight cordless impact wrench. Comfortable composite housing with soft grip to reduce vibration. Variable speed control trigger
with lock function gives more control during application. Integrated LED battery level indicator and LED work light. Supplied with belt hook for
safer storage while not in use. Requires Model No. CP1200BP 12V 1.5Ah Lithium-ion Battery and Model No. CP1200MC Battery Charger.
3. SPECIFICATION
Model No.. .................................................................
CP1204
Battery options
12V 1.5Ah Li-ion, 12V 3Ah Li-ion, 12V 4Ah Li-ion (not included)
Consumable parts
C
P1200BP - Battery 12V 1.5Ah,
C
P1200BP3 - Battery 12V 3Ah,
C
P1200BP4 - Battery 12V 4Ah (not included)
Drive ..........................................................................
3/8” Sq
Impact rate ...........................................................
0-3500bpm
M
ax. torque
.....................................................
80Nm (58lb.ft)
No load speed .......................................................
0-2500rpm
Noise power/pressure ..........................................
85/74dB(A)
V
ibration/uncertainty ........................................
2.898/1.5m/s²
Replacement parts .....................
CP1200MC - Mains charger
C
P1204 | Issue 2 11/05/20
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves
Wear ear
protection
Wear a mask
fig.1
