5.3.
SWITCH ON/OFF
5.3.1.
SWITCHING ON (SEE FIG.8)
Slide buttons in the order described in fig.8. Move the on/off switch forward to the tool head and press the front part of the on/off switch
down until it latches. Then you can release the on/off switch. Your tool is now locked on for continuous use.
5.3.2.
SWITCHING OFF (SEE FIG.9)
Slide buttons in the order described in fig.9. Push down the back of the on/off switch and move the on/off switch backwards to the rear
of the tool to switch off.
5.4.
SPEED ADJUSTMENT (SEE FIG.10)
The tool has a variable speed control for precise speed adjustment. Set it to the required speed for operation. The required speed is
dependent on the material and is to be determined by a practical trial.
5.5.
BATTERY CAPACITY INDICATOR (SEE FIG.11)
Your tool is equipped with battery capacity indicator. When the tool is on, the battery capacity indicator will light up to show the
amount of charge left in the battery.
5.6.
HAND GRIP AREA (SEE FIG.12)
Hold the tool firmly when in operation as shown in Fig.12.
5.7.
CUTTING (SEE FIG.13)
WARNING!
For cutting metal, always work with the wheel guard for cutting.
When cutting, work with moderate feed, adapted to the material being cut.
DO NOT
exert pressure onto the cutting disc, tilt or oscillate
the machine.
8
DO NOT
reduce the speed of running down cutting discs by applying sideward pressure.
The machine must always work in an up-grinding motion. Otherwise, the danger exists of it being pushed uncontrolled out of the cut.
When cutting profiles and square bar, it is best to start at the smallest cross section.
5.8.
ROUGH GRINDING (SEE FIG.14)
WARNING!
Never use a cutting disc for rough grinding applications. Serious injury to yourself and others can be caused by using the
tool for wrong applications.
WARNING!
DO NOT
switch the grinder on whilst the disc is in contact with the workpiece. Allow the disc to reach full speed before
starting to grind.
9
Always position the guard so that as much of the exposed disc as possible is pointing away from you.
9
Be prepared for a stream of sparks when the disc touches the metal.
9
For best tool control, material removal and minimum overloading, maintain an angle between the disc and work surface of
approximately 15°-30° when grinding.
fig.8
fig.9
fig.10
fig.11
fig.12
fig.13
fig.14
CP108VAGBO Issue 1 29/04/2021
Original Language Version
© Jack Sealey Limited