9
Standing ladders shall not be used as a leaning ladder unless it is designed to do so.
8
DO NOT
stand on the top two steps/rungs of a standing ladder without a platform and a hand/knee rail.
1.3.
SAFETY REQUIREMENTS FOR EXTENDING LADDERS
9
Check the extending ladder rung locking device before use.
2. INTRODUCTION
E
N 131 Approved 4-way scaffold ladder. Two 6-rung aluminium ladders can be used as extending ladder, single ladders, step ladder or complete
scaffolding unit. Supplied with hand rail.
3. SPECIFICATION
Model No: ...................................................................
ASCL2
C
losed Length: .........................................................
1670mm
Extension Ladder: ....................................................
2700mm
Maximum Load: ........................................................... 150kg
Maximum Platform Height: ......................................... 950mm
Maximum Width (across feet): ................................... 950mm
Platform Length: .......................................................
1320mm
Step Ladder Height: .................................................
1600mm
4. ASSEMBLY
4.1.
Bolt the foot cross members to the bottom of each ladder.
The feet are already attached to the cross members. Refer to fig.1.
4.2.
WORK PLATFORM
WARNING!
Assembling the work platform is a two-man task.
4.2.1.
Attach the platform, at the desired height, to one ladder only, fig.2.
Note:
Ensure that the hole for the hand rail is nearest to the outer face of the ladder.
4.2.2.
Attach the support stay between the platform and the ladder by inserting it first into the platform and then attaching it to the ladder,
fig.2.
4.2.3.
Lift the platform assembly to the horizontal position and attach the second ladder.
Note: Ensure that the hole for the hand rail is nearest to the outer face of the ladder.
4.2.4.
Fit hand rail, fig.3.
WARNING!
The platform height must not exceed
0.95 metres
for reasons of stability.
Note: The maximum loading of the platform when assembled is 150kg.
4.2.5.
STAIRWAY WORK PLATFORM
WARNING! Assembling the stairway work platform is a two-man task.
4.2.6.
Bolt the foot cross members to the bottom of each ladder. The feet are already attached to the cross members, fig.1.
4.2.7.
Attach the stairway work platform, at the desired height, to the ground-based ladder.
4.2.8.
Attach the support stay between the stairway work platform and the ground-based ladder by inserting it first into the platform and
then attaching it to the ladder, fig.2.
4.2.9.
Lift the other end of the work platform to the horizontal position and attach it to the second ladder, located on the upper step of the
stairway.
4.2.10.
A
ttach the second support stay between the stairway ladder and the work platform, fig.2.
4.2.11. T
he maximum height above the ground of the steps on which the stairway ladder is to located when assembled is
0.56 metres
, fig.2.
▲
DANGER! Never attempt to climb the scaffolding to get onto the work platform. Always access the work platform using a
separate set of steps.
Note: The maximum loading of the stairway work platform when assembled is 150kg.
fig.1
fig.2
fig.4
fig.3
Original Language Version
© Jack Sealey Limited
A
SCL2 Issue:2 (H,F) 11/11/21
