5.5.
square the frame. make sure the measurements from corner to corner are equal in distance before tightening the bolts.
5.6.
Position back panels and fix in place as per fig.5.
5.7.
ensure all screws are in place and have been tightened.
5.8.
Attach top work surface as per fig.6.
5.9.
Position a drawer on a set of runners and push it carefully until it stops. If the operation is not smooth remove drawer and repeat.
5.10.
repeat for other drawers.
5.11.
if the drawer needs to be removed pull the draw all the way out, then push the plastic release leaver on the ball bearing slides one up
and one down as shown. fig.6. Then pull the drawer completely out.
A
PMS82 | Issue 1 13/02/18
Original Language Version
© Jack sealey limited
fig.5
fig.6
