4. OPERATION
4.1.
Ensure all measuring surfaces are clean and then turn on caliper by pressing ‘ON’ button. Wait at least one second before use.
4.2.
Loosen locking screw and close caliper; if read-out does not show zero when in closed position, reset by pressing ‘Zero’ button.
4.3.
Select inch or mm units, as required, with the metric/imperial selector. Check that display shows the required units.
4.4.
Measurements will now be shown directly on the LCD display.
4.5.
A new zero may be obtained, at any open position of the caliper, by pressing the zero control.
4.6.
When finished, turn off and store caliper in a safe, dry, childproof location.
5. MAINTENANCE
5.1.
BATTERY INSTALLATION/REPLACEMENT
If the display is blank or the digits are flashing the battery voltage is too low, replace the battery with a new SR44 power cell. If the digits
do not change when buttons are pressed or probe is moved, remove the battery for 1 minute to reset the unit. The battery should be
removed if the gauge is not to be used for a long period of time.
5.1.1. Lift off the battery cover (fig.1.9) after removing the two screws.
5.1.2. Remove exhausted battery and fit replacement with +ve side uppermost and fix the cover back into place using the two screws.
5.1.3. Dispose of old battery in a safe and approved manner. Do not burn.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
BATTERY REMOVAL
(For removal details see section 5)
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme.
Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
AK9621EV Issue: 2 - 07/09/17
Original Language Version
© Jack Sealey Limited
