INSTRUCTIONS FOR:
PROFESSIONAL SOLDERING/HEATING KIT
MODEL No:
AK2962
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
2. INTRODUCTION
3. CONTENTS
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment,
make sure you know where the nearest fire extinguisher is.
WARNING!
Always wear approved eye / face protection when operating the torch.
WARNING! DO NOT
use the torch if you notice that it is damaged or if there could be a gas leak from it.
WARNING!
Butane gas is extremely flammable, handle with care.
WARNING!
Always point the torch away from the eyes and body when igniting and during operation.
WARNING! DO NOT
put the torch down when it is lit,
DO NOT
leave it unattended.
WARNING!
The flame is not easily visible in bright daylight.
WARNING!
Ensure the flame is completely extinguished after use.
DO NOT
use water to cool the torch down.
WARNING!
Only use in a well ventilated area.
DO NOT
use the torch in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential hazard. Keep
flammable material away from the torch when operating.
DO NOT
operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT
hold any workpiece by hand.
DO NOT
touch the workpiece close to the heated area as it will be very hot. Allow to cool.
DO NOT
operate the torch if it is damaged as this may cause failure and/or possible personal injury.
DO NOT
touch the top of the torch during or immediately after use, as it will be very hot. Allow to cool.
DO NOT
allow children to operate the torch.
After use, allow the torch to cool before storing it.
When not in use, store away from direct sunlight in a safe, dry, childproof location.
DO NOT
store at over 40°C, such as in a car in hot weather.
High quality, lightweight torch kit. Suitable for heating, soldering and shrinking. Powered by butane (lighter fuel) and features a piezoelectric ignition
switch. Supplied with an anti-ignition cap and features gas/flame control. Torch is fitted with a retractable stand.
Original Language Version
© Jack Sealey Limited
AK2962 Issue: 1 - 11/08/14
AK2962
Soldering torch
Hot Air Nozzle
Deflector Nozzle
Soldering Head
3 x Soldering Tips
Hot Knife
Soldering Sponge
Solder
