WARninG! if an electrical fuse blows, ensure it is replaced with an identical fuse type and rating.
8
DO nOT
eat or smoke whilst spraying.
8
DO nOT
spray near naked flames.
8
DO nOT
leave the compressor running unattended.
8
DO nOT
operate the compressor whilst under the influence of drugs, alcohol or other intoxicating medication.
8
DO nOT
carry the compressor while operating the air brush.
8
DO nOT
cover the compressor or restrict air flow around the machine whilst operating.
8
DO nOT
allow anyone to operate the compressor unless they have received full instructions.
nOTE:
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.
2. inTRODUCTiOn
Q
uiet running piston pump, powered by a 122W motor - suitable for most air brushes. Requires no lubrication and the air supply from the unit is oil free.
Supplied with an air filter regulator and pressure gauge.
3. SPECiFiCATiOn
model no: ...............................................................
AB900.V4
Power: ...........................................................................
122W
Supply: ...........................................................................
230V
Free air delivery: .........................................................
0.8cfm
Air pressure: ..................................................................
50psi
Air outlet size: .............................................
1/8”BSP/1/4”BSP
4. PREPARATiOn
4.1.
Remove compressor from packaging and inspect for any damage. If anything is found to be missing or damaged contact your supplier.
4.2.
The compressor should be operated in a position that allows good air circulation around the unit.
5. OPERATiOn
WARninG! Ensure that you have read, understood and apply Section 1 safety instructions.
5.1.
Situate the compressor in a convenient position for the compressor on sheets of paper or card etc. ensure the rubber feet are in direct
contact with the work surface.
8
DO nOT
operate the unit in an enclosed space and ensure that there is adequate air space around the unit.
5.2.
Attach the air brush hose to the air outlet, use PTFe tape to ensure correct seal.
5.3.
Plug the mains lead into a convenient socket but do not switch on until you have fully prepared the medium to be sprayed, the air brush
and the item/surface to be sprayed.
5.4.
Switch on the unit. The compressor will then provide a constant air flow to the air brush. The compressor motor will cut-in and out
automatically to maintain the required pressure as determined by the user setting on the regulator.
5.5.
Refer to the air brush instructions for the correct operating pressure. To adjust the pressure, first pull up the regulator knob to unlock it.
To increase the pressure, turn the knob clockwise. To decrease the pressure, turn the knob anti-clockwise. monitor the result on the
pressure gauge. When correct pressure has been obtained, push down the regulator knob to lock it.
5.6.
Refer to the air brush manufacturer’s instructions for the correct spraying technique.
5.7.
DO nOT
leave the compressor running for any length of time with the air brush attached but not being used. If there is a pause in your
work switch the compressor off.
Original Language Version
© Jack Sealey limited
A
B900.V4 | Issue:1 23/09/19
