5.4.
tRANspoRtiNG tHe loAD
WARNiNG! ensure you have read, understood and apply section 1 safety instructions.
5.4.1. Ensure the jack saddle is fully lowered, then secure the load by placing the support chains over the load, pull taut and engage with
hook on opposite side of the saddle. tighten wing nut.
5.4.2.
transport the load over level and solid surfaces only, preferably concrete, and ensure that the floor is swept clean
.
5.4.3. continually monitor the load in transit. Keep all other persons at a safe distance.
DANGER!
DO NOT use on tarmacadam, or any soft surface as jack may sink or topple. Serious or fatal injury may result.
DANGER!
Should jack tip or lean for any reason
STOP whAT yOUR ARE DOING AND MOVE QUICKLy TO A SAFE DISTANCE.
DO NOT TRy TO hOLD OR STEADy the JACK.
Serious personal or fatal injury may result.
5.5.
Re-iNstAlliNG A tRANsMissioN
to transport, reposition beneath a vehicle, and raise a load up, reverse the procedures outlined above.
6. MAiNteNANce
IMPORTANT:
Only fully qualified personnel should attempt maintenance or repair.
6.1.
When the jack is not in use, the saddle must be in the lowest position to minimise ram and piston corrosion.
6.2.
oil moving parts, and grease the tilt mechanism. Wipe excessive oil and grease off and keep jack clean.
6.3.
check hydraulic oil regularly with the saddle in the lowest position.
a) remove air bleed screw (fig.1.017) and add oil, if necessary, via screw hole.
b)the hydraulic oil should be changed once a year. contact your authorised dealer for information.
WARNiNG!
Use only good quality jack oil, such as seAleY HYDRAUlic JAcK oil. Do Not use brake fluid as this will
damage the seals.
6.4.
Before each use check for any visible damage to welds and ensure components are not damaged, broken, cracked, bent,
malfunctioning, distorted, worn, loose, leaking, dirty, noisy or missing (see section 4). If any suspect item is found remove jack from
service and take necessary action to remedy the problem.
Do not use the jack if you believe it to have been subjected to abnormal load or shock. Inspect and take appropriate action.
6.5.
Periodically check the pump piston and piston rod for signs of corrosion. clean exposed areas with a clean oiled cloth.
IMPORTANT:
NO RESPONSIBILITy IS ACCEPTED FOR INCORRECT USE OF ThE MAChINE.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK.
DO NOT RETURN JACKS
TO US.
Please telephone 01284 757500 to obtain address and ‘phone number of your local agent. If jack is under guarantee please contact
your dealer.
De-commissioning:
should the jack become completely unserviceable, draw off the oil into an approved container and dispose of the jack
and the oil according to local regulations.
pRoBleM
cAUse
solUtioN
Jack will not lift.
Jack will only lift halfway.
Jack will not hold load.
Poor lifting.
saddle tilt screw too tight.
Jack will not lower.
release valve is open or no hydraulic oil.
Defective suction valve or delivery valve.
Hydraulic oil low, or excess of hydraulic oil.
Defective valves, or defective piston packing.
Defective plunger packing.
Bolts and nuts may be bent or rusted.
release valve blocked by foreign object.
close release valve, adjust oil level.
contact authorised service agent.
Adjust oil level.
contact authorised service agent.
contact authorised service agent.
check, clean, oil or replace items.
clear any items from around pedal.
7. tRoUBlesHootiNG
iMpoRtANt!
Although the following may identify a problem, in most cases the problem must be resolved by your authorised service agent.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMpoRtANt:
no liability is accepted for incorrect use of this product.
WARRANtY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
iNFoRMAtioN:
for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
sole UK Distributor, sealey Group,
Kempson Way, suffolk Business Park
,
Bury st. Edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Web
Original Language Version
800GtA.V2 Issue: 2 - 23/10/09
