
Note:
Only fully qualified personnel should attempt maintenance or repair.
4.1.
When the Jack is not in use, the ram and the handle socket should be in their lowest position.
Remove the handle to inactivate Jack.
4.2.
Keep the Jack clean and lubricate all moving parts with acid free oil on a regular basis.
4.3.
To check the oil level, fully lower the Jack. Remove oil plug (Item 3). The correct oil level should be approximately 10mm below
the filler opening. If oil level is low, fill as required. Note: low oil level may result in the Jack not lifting to its fullest extent.
IMPORTANT: Use a good quality Jack oil, such as SEALEY HYDRAULIC OIL.
WARNING:
DO NOT use brake fluid, or any fluid other than hydraulic fluid as this may cause serious damage to the Jack
and will invalidate the warranty!
4.4.
Every three months remove the locking rings on the caster wheels and lubricate the ball bearings with acid free grease.
4.5.
After a year of extensive use, the oil should be replaced in order to extend the life of your equipment.
To drain the oil, remove the filler cap and valve. Make sure that no dirt is allowed to enter the hydraulic systems oil.
4.6.
Periodically check the pump piston and piston rod for signs of corrosion. Clean exposed areas with a clean oiled cloth.
De-commissioning the Jack
Should the Jack become completely unserviceable and require disposal, draw off the oil into an approved container and dispose of the Jack
and the oil according to local regulations.
4. MAINTENANCE
Sealey Group,
Bury St. Edmunds,
Suffolk.
01284 757500
01284 703534
E-mail:
20CT - Job No 143 - 07.01.98
IMPORTANT
NO RESPONSIBILITY IS ACCEPTED FOR INCORRECT USE OF THE MACHINE.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK. DO NOT RETURN JACKS
TO US. Please telephone us on 01284 757500 to obtain the address and phone number of your local agent. If Jack is under guarantee please
contact your dealer.
WARRANTY
GUARANTEE IS 12 MONTHS FROM PURCHASE DATE. PROOF OF PURCHASE WILL BE REQUIRED FOR ANY CLAIM.
INFORMATION
PLEASE CALL US FOR A COPY OF OUR LATEST CATALOGUE.
Declaration of Conformity
We, the sole importer into the UK, declare that the product listed below is in conformity with the following EEC standards and directives.
The construction file for this product is held by the Manufacturer
and may be inspected on request by contacting Jack Sealey Ltd
For Jack Sealey Ltd.
Sole importer into the UK of Sealey Quality Machinery
Model No: 20CT
20 Ton Jack
89/392/EEC
Machinery (S.I. 1992/3073 & Amendments)
Signed by John Sealey
Date 1st February 1998