SeaLevel 7204e, Руководство пользователя, Страница: 14 / 35

14
© Sealevel Systems, Inc. 7204e Manual | SL9244 11/2022
Termination & Biasing Resistors
Typically, each end of the RS-485 bus must have line terminating resistors enabled (RS-422 should
terminate the receive end only). A 120 ohm resistor is across each RS-422/485 input in addition to a 1 K
Ω
pull-up and pull-down combination that biases the receiver inputs. Use the switches detailed in the table
below to customize the interface to your specific requirements.
If using the board in an RS-485 two-wire network, enable the two switches labeled ‘L’, which tie the
positive/negative transmit/receive pairs together.
Switch Default Description
T ON Adds 120 Ω termination, OFF to remove
PU ON Adds 1 K Ω pull -up resistor in RS-422/485
Off to remove
PD ON Adds 1 K Ω pull -down resistor in RS-422/485
OFF to remove
L OFF ON to connect TX– to RX– for RS-485 two-wire
L OFF ON to connect TX+ to RX+ for RS-485 two-wire