Operating your
Assembly Instructions
1. Connect the footswitch to the sealer unit.
2. To install the optional working plate and table
install the working plate. Adjust working table heigh
Figure 5.
Working Plate and
Operation
1.
Before operating,
are clean and without residue.
2. Insert the power cord into the correct receptacle (110V).
3. Turn the power switch on.
4. Set the sealing temperature on the temperature controller depending on the material to be sealed.
(Note: Temperature on the dial is Celsius, not
temperature setting and gradually increase the temperature as needed.
the sealer to reach the set temperature.
when the unit has reached the set temperature.
5. Set the timer setting for the length of the sealing t
material to be sealed and temperature set on the temperature controller.
6. Place material to be sealed on the lower sealing jaw and press the footswitch to activate the
sealing process. The upper sealing bar will release once seal time is achieved.
8
Operating your Sealer
Assembly Instructions
Connect the footswitch to the sealer unit.
optional working plate and table, remove screws located at the front of the unit and
install the working plate. Adjust working table height to your bag specifications.
Table Installation
Before operating, check for any worn parts of the sealer. Make sure the sealing bars
are clean and without residue.
Insert the power cord into the correct receptacle (110V).
Set the sealing temperature on the temperature controller depending on the material to be sealed.
Temperature on the dial is Celsius, not Fahrenheit.) Always start with a lower
temperature setting and gradually increase the temperature as needed. Allow 5
set temperature. The light above the temperature contr
when the unit has reached the set temperature.
Set the timer setting for the length of the sealing time. Adjust seal time
material to be sealed and temperature set on the temperature controller.
sealed on the lower sealing jaw and press the footswitch to activate the
sealing process. The upper sealing bar will release once seal time is achieved.
at the front of the unit and
t to your bag specifications.
sealer. Make sure the sealing bars
Set the sealing temperature on the temperature controller depending on the material to be sealed.
.) Always start with a lower
Allow 5-10 minutes for
The light above the temperature controller will turn off
ime. Adjust seal time as needed based on
sealed on the lower sealing jaw and press the footswitch to activate the
sealing process. The upper sealing bar will release once seal time is achieved.
