SealerSales FS-205, Инструкция по эксплуатации

Страница: 3 / 4

ƒ
The machine does not use a power switch. Plug the AC
5. OPERATION 6. GETTING STARTED
ƒ
No warm-up time needed.
cord into the power source. Set the timer knob according
to the thickness of the materials to be sealed. The higher
the number on the dial, the longer the sealing time. Put
one plastic bag on the sealing platform, and then push
down the handle. The electronic circuit controls the heat
time automatically, the light turns off (to cut off the power
ƒ
Always start with the lowest setting #1.
ƒ
Increase slowly until you get a satisfactory seal.
ƒ
Once the correct setting of the timer is set, the sealer will
provide a consistent air and water proof seal every time.
y, g ( p
automatically). After 1-2 seconds, release the handle. The
perfect seal is complete.
ƒ
Should the seal appear damaged, most likely, the timer on
the setting was too high. Adjust the knob to a lower timer
setting.
7. TIPS FOR SUCCESSFUL SEALING
ƒ
Always keep the sealing platform clean. Avoid the
oxidation of the residual on the platform which will reduce
ƒ
A non-tight seal is caused by sealing time that is too low.
Adjust the knob to a higher timer setting.
ƒ
Should the plastic bag stick to the handle rubber, cooling
time needs to be longer. Keep the handle down for a short
time after the light turns off
oxidation of the residual on the platform which will reduce
the life of the heating element and the teflon.
ƒ
Do not use water to clean the sealing platform.
ƒ
Should the bottom teflon cloth wear out, it will cause a
short circuit and damage the heating element. Each
time you replace the heating element or the top teflon
ƒ
Slide the knife to cut off the rest of the bag. (Only for FS-
200C/205C and FS-300/FS-305C)
time you replace the heating element or the top teflon,
check the bottom teflon adhesive and replace if worn.
ƒ
Only use original equipment replacement wires and parts.
ƒ
A worn silicon handle rubber will influence the sealing
effect. After a long period of usage, it should be checked.
ƒ
After the timer knob has been set, the heat time duration
will remain the same for each usage. It is unnecessary to
make further adjustments.
ƒ
It is okay to leave the AC cord plugged into the power
Model FS-100/200/300/400/505 FS-200C/300C
FS-205/305/405/505 FS-205C/305C
Heating Element 2pcs 2pcs
8. SPARE PARTS
It is okay to leave the AC cord plugged into the power
source. No power is used unless the handle is pressed
down.
Heating Element 2pcs 2pcs
Teflon Cover 2pcs 2pcs
Blade -- 1pc