3
• Always connect your dehumidifier using a grounded, dedicated
electrical connection that is GFCI protected with at least 15 amp capacity.
•The use of any other type of wiring will void your warranty.
• Install dehumidifier according to all applicable local, state, and national
codes
• Be sure to follow your GFCI manufacturer’s maintenance instructions.
You will typically need to test the operation of the trip circuit monthly.
• For ease of testing and operation, it may be helpful to put the test
switch and indicator lights in a convenient location.
• Your dehumidifier should only be repaired by a qualified technician.
• Do not insert objects or your fingers into the inlet or discharge.
• Do not use water to clean the exterior of the dehumidifier. To clean unit,
unplug from power, then use a damp cloth to wipe the exterior.
• Do not stand on dehumidifier or place objects on it.
• Do not use with extension cord or plug adapter.
• Unless otherwise noted, all maintenance should be done with the unit
powered off.
Model Number: Date Of Purchase:
Specifications
Capacity @ 80°F/60%RH:
120 Pints Per Day
Airflow @ 0.0” SP:
300CFM
Operating Temp. Range:
33-105°F
Operating Relative Humidity Range:
36%-90%
COP:
2.8 L/kWh
Refrigerant:
R410A
Amperage Usage:
7.6 Amps
Power Supply:
115V/60Hz/Single Phase
Outlet Requirement:
15 Amp, 3 Prong, GFCI
Sound Level:
60 dBa
Dimensions
LxWxH:
23.75” x 14” x 16”
ETL Listed:
Yes
How It Works
WatchDog dehumidifiers use an integrated humidistat to monitor the
conditioned space. When the relative humidity goes above the selected
setpoint, the dehumidifier will energize. Air is then drawn across an
evaporator coil, which is cooler than the dew point of air. This means moisture
will condense out of the air. The air is then reheated through the condenser
coil and distributed back into the room.
Installation Requirements
• The area where the dehumidifier is located should be sealed with a vapor
barrier.
• If the unit is installed in a crawl space, all vents should be sealed.
• For proper ventilation, neither the inlet or discharge should be positioned
against a wall. The inlet needs a minimum of 12” clearance and the discharge
requires a minimum of 36” clearance.
• For the best air diffusion, install the unit so that a side panel faces the wall.
• WatchDog dehumidifiers are only intended for operation when the unit
is upright and level with the feet on the ground (unless using a WatchDog
Hanging Kit).
Содержание WatchDog NXT120C
Страница 14: ...13 Troubleshooting...
