19
www.seagullmodels.com
2) Apply the epoxy to the surface of both tail
and wing end. The tail is held in position and
install it to the wing end. Please see pictures
shown.
Remove covering.
Remove covering.
Fill epoxy.
Fill epoxy.
Fill epoxy.
1) Attach the tail to the wing. Use a hobby knife
to remove the covering at the tail and wing end.
3) With the tail held firmly in place, use a
pen and draw lines onto the tail where it and
the wing sides meet. Do this on both the right
and left sides and top and bottom of the tail.
4) Remove the tail and wing. Using the
lines you just drew as a guide, carefully re-
move the covering from between them using
a modeling knife.
Pen.
