Seagull Models SEA 362, Инструкция по сборке

Страница: 50 / 53

Cessna 208 Grand Caravan 85 inch wingspan 35-40cc
Instruction Manual.
50
5 .
6 .
M4x25mm.
If all the decals are not precut, please use
scissors or a sharp hobby knife to cut the
decals from the sheet. Please be certain
the model is clean and free from oily in-
gerprints and dust. Position decal on the
model where desired, using the photos on
the box and aid in their location.
APPLY THE DECALS
BALANCING
If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily ingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and aid
in their location.
With the wings attached to the fuselage,
all parts of the model installed ( ready to
ly), and empty fuel tanks, hold the mod-
el at the marked balance point with the
stabilizer level.
*If possible, irst attempt to balance the
model by changing the position of the
receiver battery and receiver. If you are
unable to obtain good balance by doing
so, then it will be necessary to add weight
to the nose or tail to achieve the
proper balance point.
Lit the model. If the tail drops when you
lit, the model is “tail heavy” and you
must add weight* to the nose. If the nose
drops, it is “nose heavy” and you must
add weight* to the tail to balance.
An important part of preparing the air-
crat for light is properly balancing the
model.
1) Attach the wing panels to the fuselage.
Make sure to connect the leads from the
aileron to the appropriate leads from the
receiver. Make sure the leads are not ex-
posed outside the fuselage before tight-
ening the wing bolts. Your model should
be light-ready before balancing.
2) he recommended Center of Gravity
(CG) location for your model is (80mm)
back from the leading edge at the center
of the wing.
3) When balancing your model, make
sure it is assembled and ready for light.
Support the plane upright at the marks
made on the wing with your igers or a
commercially available balancing stand.
his is the correct balance point for your
model.