WWW.SEAGULLMODELS.COM
3
.
.
KIT CONTENTS .
HINGING THE FLAP.
SEA19501 Fuselage
SEA19502 Wing Set
SEA19503 Tail Set
SEA19504 Fiberglass Cowling
SEA19505 Main Landing Gear
SEA19506 Windshield and Window Set
SEA19507 Hardware Pack
SEA19508 Decal Set
SEA19509 Pushrod Set
SEA19510 Fiberglass Wheel Pant
SEA195B Replacement Box
Note: T
he control surfaces, including the
ailerons, elevators, and rudder, are prehinged
with hinges installed, but the hinges are not
glued in place. It is imperative that you prop-
erly adhere the hinges in place per the steps
that follow using a high-quality thin C/A glue.
1) Carefully remove the flap from one of
the wing panels. Note the position of the
hinges.
ADDITIONAL ITEMS REQUIRED.
0.75- 0.91
2-stroke.
1.00 - 1.25
4-stroke.
Computer radio with 8 servos.
Glow plug to suit engine.
Propeller to suit engine.
Protective foam rubber for radio
system.
2) Remove each hinge from the wing pan-
el and flap and place a T-pin in the center
of each hinge. Slide each hinge into the ai-
leron until the T-pin is snug against the ai-
leron. This will help ensure an equal amount
of hinge is on either side of the hinge line
when the flap is mounted to the wing panel.
TOOLS & SUPPLIES NEEDED.
Thick cyanoacrylate glue.
30 minute epoxy.
5 minute epoxy.
Hand or electric drill.
Assorted drill bits.
Modelling knife.
Straight edge ruler.
2mm ball driver.
Phillips head screwdriver.
220 grit sandpaper.
90° square or builder’s triangle.
Wire cutters.
Masking tape & T-pins.
Thread-lock.
Paper towels.
3) Slide the flap on the wing panel until
there is only a slight gap. The hinge is now
centered on the wing panel and flap. Remove
the T-pins and snug the flap against the
wing panel. A gap of 1/64” or less should be
maintained between the wing panel and flap.
3
C/A glue
T-pin.
C/A Hinge.
