P47 SNAFU
Instruction Manual.
38
FLIGHT PREPARATION.
PREFLIGHT CHECK.
Check the operation and direction
of the elevator, rudder, ailerons and
throttle.
A) Plug in your radio system per the
manufacturer’s instructions and turn
everything on.
B) Check the elevator first. Pull
back on the elevator stick. The eleva-
tor halves should move up. If it they do
not, flip the servo reversing switch on
your transmitter to change the direc-
C) Check the rudder. Looking from
behind the airplane, move the rudder
stick to the right. The rudder should
move to the right. If it does not, flip
the servo reversing switch on your
transmitter to change the direction.
D) Check the throttle. Moving the
throttle stick forward should open the
carburetor barrel. If it does not, flip the
servo reversing switch on your trans-
E) From behind the airplane, look
at the aileron on the right wing half.
Move the aileron stick to the right.
The right aileron should move up and
the other aileron should move down.
If it does not, flip the servo reversing
switch on your transmitter to change
the direction.
1) Completely charge your trans-
mitter and receiver batteries before
your first day of flying.
2) Check every bolt and every
glue joint in the
P47 SNAFU
to en-
sure that everything is tight and well
3) Double check the balance of the
airplane. Do this with the fuel tank
4) Check the control surfaces. All
should move in the correct direction
and not bind in any way.
5) If your radio transmitter is
equipped with dual rate switches
double check that they are on the low
rate setting for your first few flights.
6) Check to ensure the control sur-
faces are moving the proper amount
for both low and high rate settings.
7) Check the receiver antenna.
It should be fully extended and not
coiled up inside the fuselage.
We wish you many safe and enjoyable flights
with your P47 THUNDERBOLT SNAFU.
38
8) Properly balance the propeller.
An out of balance propeller will cause
excessive vibration which could lead
to engine and/or airframe failure.
Содержание P47 SNAFU
Страница 12: ...P47 SNAFU Instruction Manual 12 12 Drill hole 3mm Drill hole Knife Cut C A glue ...
Страница 25: ...WWW SEAGULLMODELS COM 25 M3x10mm M3 lock nut M3 clevis 30mm ...
Страница 26: ...P47 SNAFU Instruction Manual 26 Cut Cut Insert bomb onto the wings Epoxy Epoxy ...
Страница 37: ...WWW SEAGULLMODELS COM 37 37 ...