17
www.seagullmodels.com
Wing.
M3 lock nut.
M3 lock nut.
M3 clevis.
60mm.
100mm.
Aileron.
AILERON PUSHROD HORN INSTALLATION
Flap
.
Flap
.
Wing
.
Wing
.
Repeat the procedure for the other aileron servo.
Cut.
3) Slide the stabilizer into place in the pre-
cut slot in the rear of the fuselage. The stabi-
lizer should be pushed firmly against the front
of the slot.
INSTALLING THE HORIZONTAL STABILIZER.
1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the trail-
ing edge, and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge of
the stabilizer.
Draw center line.
2) Using a modeling knife, carefully remove
the covering at mounting slot of horizontal sta-
bilizer ( both side of fuselage).
