Bunker Bu 133
Instruction Manual.
30
3) Begin placing tension on the wires,
working from the ends that have been
crimped to the ends that have not. There
should be light tension on all the cables,
but not enough to change the position
of the wing. Once the cables have been
tensioned, begin by securing the crimps
where the cables pass through the tabs
near the fuselage. Then secure the crimps
at the cable ends. Once tensioned, use
side cutters to trim the excess cable.
4) Locate the wing transport frams and
rubber bands. Slide the frames between
the top and the bottom wing as shown.
Use a rubber band to hold the frame to
the top and bottom wing.
Wing bolt
